Roidmi CFJ01RM User manual

HIGH SPEED HAIR DRYER
Please read this manual carefully before starting to use the product store it properly for future reference

Safety Precautions
In order to avoid accidental injuries such as electric shock or fire caused by
improper use, please read the instruction manual carefully before use and keep
it properly for future reference.
WARNING
1
1. Do not use this appliance near bathtubs showers,
basins or other vesse ls containing water.
2. This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or reasoning capabilities, or lack of experience
and knowledge only if they have been given supervision
or Instruction by a responsible person concerning
use of the appliance in a safe way and understand the
hazards involved. Cleaning and user maintenance shall
not be made by children without supervision.
3.Do not unplug by pulling on the cable.To unplug , grasp
the plug , not the cable . The use of an extension cable is
nof recommended.

2
4. If the supply cable is damaged it must be replaced or
repaired by the manufacturer, its service agent or similarly
quolified persons in order to avoid a hazard.
5. Keep away from pacemakers defibrillators, credit cards
and electronic storage media.
6. This appliance has a non-self resetting thermal cut-out
safety device to prevent overheating.If your appliance cuts
out, unplug it from the mains supply socket and leave to cool.
7.Whenthe appliance is used in a bathroom , unplug it
after use since the proximity of water presents a hazard
even when the appliance is switched off.For additional
protection when the appliance is used in a bathroom ,
it is recommended that a Residual Current Device( RCD ) ,
with a residual operating current not exceeding 30 mA is
installed in the electrical circuit supplying the bathroom.
Contact a qualitied electrical installer for advice.
8 . Do not handle any part of the plug or appliance with
wet hands.

3
9 . Do not use the appliance for any other purpose than
drying hair.
10. Do not allow to be used as a toy. Close attention is necessary
when used by or near children.Children should be
supervised to ensure that they do not play with the appliance.
11 . Do not stretch the cable or place the cable under strain.
Keep the cable away from heated surtaces and do not
wrap the cable aound the appliance.
12 . Do not use any lubricants ,cleaning agents , polishes
or air fresheners on any part of the appliance.
13 . Contact the Helpline when a service or repair is
required .Do not disassemble the appliance as incorrect
reassembly may result in an electric shock or fire.
14 . If the appliance is not working as it should , if it has
received a sharp blow , if it has been dropped , damaged,
left ,outdoors , or dropped into water,do not use and
contact the Helpline.

4
WARNING: Do not use this appliance near water
15.In order to avoid a hazard due to inadvertent resetting
of the thermal cut-out,this appliance must not be
supplied through an external switching device , such as a
timer ,or connected to a circuit that is regularly switched
on and off by the utility company , orplugged into any
socket wherele the electrical supply is unstable or liktely
to be turned off.

1. Do not use and store this product under extreme adverse
conditions, such as extreme temperatures. It is recommended
to use it indoors at an ambient temperature of 0-35℃,
please store it in a cool and dry place.
2. Do not wave around the hairdryer or let children play with
the hairdryer. etc. (so as not to cause injury or damage to it).
3.Do not drop this product, collide with other objects or apply
pressure to this product (so as to avoid fire or electric shock
accidents due to failure).
4. The parameters in the manual are only measured in a
laboratory environment, and the parameters will be slightly
different due to individual product differences.
5.Theillustrationsofproducts,accessories,anduserinterfacesin
themanualareallschematicdiagramsandareforreference only.
Due to product updates and upgrades, the actual product and
the schematic diagram may be slightly different, please refer
to the actual product.
CAUTION
5

6
Product Introduction
Status Indicator
Power Cable
Air Outlet
Magnetic Ring
Air Inlet Filter Cover
Temperature
Control Button
Switch/Wind
Speed Button
This symbol on the fuselage indicates
"WARNING : Do not use this appliance near wate"

Annex
Product installation
Installation of accessories
Gentle Air Nozzle Modeling Nozzle Wall-mounted Storage Rack Storage Bag
The two types of magnetic attachment nozzles can be easily attached by aligning the nozzles with the magnetic ring.
To facilitate convenient use of this product, it is equipped with special nozzle attachments. When using the hairdryer, the nozzle attachments
can be directly attached to the hairdryer.
1.Gentle Air Nozzle 2. Modeling nozzle
7

STEP ONE:Uncover the sticker behind the wall-mounted storage rack;
STEP TWO:Paste on the wall at a suitable position; STEP THREE:The wall-mounted hair dryer vertically into the
storage rack, the hook hung on the power line;
When installing accessories, please turn off the blower and cool to normal temperature to avoid burns.
Note
3. Wall by
8
4. If the supply cable is damaged it must be replaced or
repaired by the manufacturer, its service agent or similarly
quolified persons in order to avoid a hazard.
5. Keep away from pacemakers defibrillators, credit cards
and electronic storage media.
6. This appliance has a non-self resetting thermal cut-out
safety device to prevent overheating.If your appliance cuts
out, unplug it from the mains supply socket and leave to cool.
7.Whenthe appliance is used in a bathroom , unplug it
after use since the proximity of water presents a hazard
even when the appliance is switched off.For additional
protection when the appliance is used in a bathroom ,
it is recommended that a Residual Current Device( RCD ) ,
with a residual operating current not exceeding 30 mA is
installed in the electrical circuit supplying the bathroom.
Contact a qualitied electrical installer for advice.
8 . Do not handle any part of the plug or appliance with
wet hands.

Product use
Switch/wind speed adjustment
Temperature control button
Switch is pushed up to open the blower speed in the standard default file, continue to push up the switch Winds potent gear, pushed down to
the bottom of the switch, close the hair dryer.
In the running state, click the temperature control button to switch between the three modes of cold air/warm air/hot air.
Shut down
Shut
down
①
Turn on
Turn on
②
Powerful file
Switch gear
③
9
Wind temperature state
Cold wind
Warm air
Hot air
Indicator status
Blue light
Yellow light
Red light
9 . Do not use the appliance for any other purpose than
drying hair.
10. Do not allow to be used as a toy. Close attention is necessary
when used by or near children.Children should be
supervised to ensure that they do not play with the appliance.
11 . Do not stretch the cable or place the cable under strain.
Keep the cable away from heated surtaces and do not
wrap the cable aound the appliance.
12 . Do not use any lubricants ,cleaning agents , polishes
or air fresheners on any part of the appliance.
13 . Contact the Helpline when a service or repair is
required .Do not disassemble the appliance as incorrect
reassembly may result in an electric shock or fire.
14 . If the appliance is not working as it should , if it has
received a sharp blow , if it has been dropped , damaged,
left ,outdoors , or dropped into water,do not use and
contact the Helpline.

CAUTION
10
Product Cleaning
1.Wipe the air outlet with a paper towel or towel,deal with attachments
such as dust or hair.
Before cleaning the product, please make sure to unplug the product from the main power socket and clean
it after turning it off and cooling.
2.Use dry lint-free cloth, soft brush, toothbrush and other tools;Remove
the attachments on the surface of the stainless steel filter screen
at the air inlet.
1. After use, please be sure to turn off the power and unplug the socket.
2. It is recommended to clean it regularly, and if there is dust and other foreign objects attached or blocked, please clean it in time.
3. Do not clean the filter with water.

Name
Product performance failure table
Cannot turn on/off under normal use
The temperature control button does not work under normal use
Performance failure
High Speed Hair Dryer
11
Basic Parameters
Product name Product model CFJ01RM/CFJ01RMB/CFJ01RM*
High Speed Hair Dryer
Rated working voltage
243×38×49.7mm
Dimensions
220V-240V~
Rated frequency 50Hz-60Hz
Rated power 1000W
Warranty Description
This product is guaranteed for a period of 12 months(defined by local law)from the date of purchase against any failure resulting from
manufacturing or material defects.
This warranty does not cover damage caused by improper installation, improper use, or normal wear and tear of the product.
More specifically, the warranty does not cover:
Damage or problems caused by improper use , accident , alteration or electrical connection of improper intensity or voltage.
Modified products , those whose warranty sel or serial number have been damaged , altered , removed or oxidized.
Failure of the battery due to overcharging or failure to observe the safety instructions explained in the instruction manual.
Cosmetic damage , including scratches , dents , or any other element .
Damage caused by any intervention carried out by an unauthorised person.
Defects caused by normal wear and tear or due to normal ageing of the product .
Software updates due to a change in network setting.
Product failures due to the use of third party software to modify , change or adapt the existing software.
Product failures caused by use without accessories approved by the manufacturer.
Oxidised products .

12
Terms and conditions of implementation:
To obtain a warranty service, you are requested to return your product to the customer service desk of your retail outlet with your
proof of purchase(receipt, invoice,....),the product and its supplied accessories, with its original packaging.
It is important to have the date of purchase ,the model and the serial or IMEI number on hand as information( this information usually
appears on the product, the packaging or your proof of purchase).
Failing this, you must return the product with the accessories necessary for its proper operation(power supply, adaptor, etc.).
In the event that your claim is covered by the warranty, the after-sales service may, within the limits of local law, either:
Repair or replace defective parts.
Exchange the returned product with a product that has at least the same functionality and that is equivalent in terms of performance.
Refund the product at the purchase price of the product mentioned on the proof of purchase.
If one of these 3 solutions is used, this does not give rise to the extension or renewal of the warranty period.
Product maintenance record
Repair centre Repair dateReplacement partsFault description Maintenance engineer
Product warranty card
Username Product name and model
Product host serial number
Product purchase date
Mailing address
Contact details
This warranty card contains consumer personal information, please keep it properly by yourself

13
Manufacturer:ROIDMI INFORMATION TECHNOLOGY CO., LTD.
Address: 4F,C8 BUILDING,NO.1699 HUISHAN ROAD,LIFE SCIENCE AND TECHNOLOGY PARK,HUISHAN DISTRICT,
WUXI,JIANGSU,PRC
Executive Standard:(EC) 1275/2008: 2008-12-17;Amended by (EC) 278/2009:2009-04-06, (EC) 642/2009:2009-07-22, (EU) 617/
2013:2013-06-26; (EU) 801/2013:2013-08-22；EN 50564:2011;EN 60335-1:2012+A11:2014+A13:2017+A1:2019+A14:2019+A2:2019;
EN 60335-2-23:2003+A1:2008+A11:2010+A2:2015;EN 62233:2008;EN 55014-1:2017/A11:2020;EN 55014-2:2015;EN 61000-3-2:2014;
EN IEC 61000-3-2:2019;EN 61000-3-3:2013;EN 61000-3-3:2013/A1:2019;2011/65/EU
Service Email : [email protected]
Enterprise Website: www.roidmi.com/en
No.09.2021
Made in China
CLASS II EQUIPMENT