Ronix RWMB-1000 User manual

SPECIFICATION
PARTS SUPPLIED
5mm (Q’ty:1)
M6x20mm (Q’ty:4)
M3x12mm (Q’ty:4)
SUS Bushing (Q’ty:4)
Assembly Screw : for main bracket Mounting Screw : for Pole mount adaptor
DIMENSION
(unit: mm)
Wall Mount Bracket EVA Rubber
(Q’ty:1)
Installation
Guide
Mounting
Template
L-Wrench
APPLICATION
Pole mount adapter
(mounting on the
pole-like structure)
Surface mount or
Tilted mount adaptor
PRIOR to USE
Install the mount onto a strong structure such as concrete
wall. Use the supplied accessories when installing the
mount bracket depends on mounting position.
Mounting Screw
M5x40mm (Q’ty:4)
Plastic Anchor
8x35mm (Q’ty:4)
Spring Washer (Q’ty:4)
M4x12mm (Q’ty:4)
Screwed in Mount-Plate
211
252.7
Ø141.4
108
80
150
183
Aluminum cast
Wall mount for a Vandalproof dome
Ø141.4(W)x183(H)x252.7(L)
1 kg (2.2 lb)
Construction:
Environment:
Dimension(mm):
Weight:
3mm(Q’ty:1)
L-Wrench
Please Turn Over
Wall Mount Bracket
for Vandalproof dome

for Pole mount adaptor
Vandalproof dome
Flush mount unit
Assembly Screw
(M3x12mm)
Mount-Plate
Dome Cover
EVA Rubber
Missing line
Surface mount
adaptor
Mounting Screw
(M5x40mm)
Screw (M6x20mm)
with Spring Washer
Release Paper
Bushing
1. Locate the mounting template at the installation position and drill the wall.
2. Remove the release paper of EVA rubber and attach to bottom of the bracket.
(If the bracket is installed on outdoor wall, take off the missing line for water drain)
3. Place the mount bracket on pre-drilled position and fix it through using mounting screws.
Route the power and BNC cable before mount on the wall.
4. Open the dome cover by loosening screws.
5. Affix the surface mount adaptor to the mount plate using the assembly screws (M3x12mm).
Assemble vandalproof dome flushmount unit to the surface mount adaptor.
6. Set the camera’s viewing angle and adjust zoom&focus.
7. Put the dome cover to the dome unit and tighten screws.
* The vandalproof dome is not
included in this package.
MADE IN KOREA RME0500-V1
INSTALLATION