Roper Rhodes Minerva Toilet Seat User manual

Toilet Seat Fitting Instructions & Product Care
Toilet seat
Hinge components
Please read carefully before attempting to fit the seat. If you are not the end user,
please make sure the aftercare instructions are made available for the end user to
read.
Stainless steel cover cap
Screw
Adjustment plate
Hinge anchor
Rubber washer
Fixing bolt
Quick release
button
Hinge socket
1. Fixing the hinge anchor:
Insert the Adjustment plate and Rubber washer into their
positions on the Hinge anchor component.
Place the Screw through the components and into the hole
on the toilet pan.
Screw the fixing bolt onto the Screw from the underside of
the toilet pan.
Use a screwdriver to tighten from the top. NOTE: don't fully
tighten at this stage as some adjustment may be required.
Pin

2. Fitting the seat:
Adjust the position of the hinge anchors so that the pins
align with the sockets on the hinge (see hinge adjustment
below).
Insert the pins into the hinge sockets and firmly press down
until you hear them 'click' into position.
Now consider if any adjustment of the hinge anchor
positions is required to make the seat line up with the edges
of the toilet pan.
When you are satisfied the seat is in the correct position fully
tighten the screws using a screwdriver (shown in step 1) and
cover each of the hinge anchors with the stainless steel
cover caps.
3. Quick release mechanism:
This toilet seat is designed so it can be quickly and easily
removed for cleaning the toilet pan.
To activate the quick release lift the lid and seat up.
Press the buttons on the inner ends of the hinges and lift.
To replace the seat align the sockets with the pins and firmly
press into position.
AFTERCARE INSTRUCTIONS
This toilet seat has a very hardwearing finish. The seat should
however be treated with care.
1. Clean the surfaces weekly with a soft damp cloth and mild
soap solution.
2. Do not use neat bleach, powder cleaners or cream cleaners.
3. Do not scour or scrub the surface.
4. Replacement hinges,fixings, and washers and can be
obtained directly from Roper Rhodes Ltd
at the address below. If possible please quote the seat product
code in all correspondence.
5.WARNING - do not stand on the lid or ring of your toilet seat
(for example when decorating the bathroom).
Click!
Press
Roper Rhodes Ltd, Brassmill Lane Trading Estate, Bath, BA1 3JF
Tel: [phone] | Fax: [phone] |Email: [e-mail] |Web: www.roperrhodes.co.uk
A
B
Hinge Adjustment:
Maximum adjustment of the pin position is achieved by
rotating the hinge anchor around the screw (adjustment A).
Further fine adjustment of the pin position can be achieved
by sliding the screw in the adjustment plate (adjustment B)
Pin
Adjustment plate