ROSE DISPLAYS MultiStand AnoFrame Top Load User manual

1Lay out the base components prior to assembling as shown (be sure that the upright assembly bosses
are facing upward). Use the two rectangular tubes to connect the base sides. Press joints together
firmly to ensure connectors engage the tubing.
Signware
AnoFrame Top Load
MultiStand
35 Congress Street, Salem, MA 01970 | 800.631.9707 | www.rosedisplays.com | [email protected]
AnoFrame™is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use of these products.
2 Full Rails
12AF100RT-B
A
2 Split Rails
12-0200-B
B C D E F G
1 Short
Rail
2 long base connec-
tors
2 Base Sides
1 Right PN#
1 Le PN#
4 Casters
PN#
4 Pairs Brackets
PN#
Caution
Sharp
Corners!
(Up)
(Up)
F
F
E
E
P1
Completed base
(2) Bosses face
upward
(4)Threaded
corners face
floor
Part Layout

Tabs face out
Tabs
face out
Smooth
sides
face out
2
3
Next, lay out the graphic frame components. Insert corner brackets into the tracks in each end of the long
side rails . Use the short bottom rail and 2
split top rails to connect the long rails together. 
Carefully press all corners together firmly to close all gaps in the corners. 
Install the assembled graphic frame onto the base
frame. Press together firmly to engage tubing onto the
base connector.
*2 in each corner
** Single Bottom Rail
Signware
Plastic cap
*Single rail
Two thin
split rails
Plastic cap
Caution
Sharp
Corners!
** Split Top Rail
D
B
A
A
35 Congress Street, Salem, MA 01970 | 800.631.9707 | www.rosedisplays.com | [email protected]
AnoFrame™is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use of these products.
P2

4
5
Tilt the assembled frame onto its side. Thread the 4 casters into the inserts in the bottom corners of the
base frame. Insert the bottom edge of the graphic between the split top rails to install.
Stand the frame upright and roll it into position.


Completed assembly shown
(4)
Casters
G
35 Congress Street, Salem, MA 01970 | 800.631.9707 | www.rosedisplays.com | [email protected]
AnoFrame™is a trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales
agent may be held liable for injury, loss or damage resulting from the use of these products.
P3