Rousseau 3506 User manual
OWNER’S MANUAL
IMPORTANT
Read and understand all safety guidelines and
instructions carefully before using.
Quality Power Tool Accessories
Power Switch
Model3506
2
GENERALINFORMATION
Youhavepurchased a ROUSSEAU CO.POWERSWITCH. This producthasa
lighted 120 volt, single phase, rocker switch with 15Amp circuit breaker switch
andincludes crashbarfor fast,safe shutoff.Extralong8’ x14 gaugepowercord
is perfect for router tables, band saws, table saws and other applications.
WARRANTY
All electrical components have a one year warranty from the date of purchase.
This warranty applies to defects in materials and workmanship only. We will
repair or replace the product or part(s) at our discretion. This warranty does not
apply to product failure or defects due to direct or indirect misuse, abuse, negli-
gence,accidents,alterations, repairs orlackof maintenance. The itemmustbe
shipped prepaid to our Clarkston, WA location. If items must be returned for
warrantyservice,calltoreceiveaReturn GoodsAuthorization(RGA)numberand
furtherinstruction.
SAFETYGUIDELINES
Unplugtoolfromswitch before making adjustments totool.
Place switch where it is visible and easy to reach.
Neverremovegroundingprongfromcord.
Intended to run only one tool at a time.
Do not use in rain or near water.
Donotuse nearexplosive,flammable materialsorvapors.
Do not use if cord is cracked or damaged.
Makecertainthatcutterisclearofworkpiece anddebrisbefore
turningswitchto “ON”.
Always follow the safety recommendations and guidelines
provided by the manufacturer of your tools. When in doubt
refertoyour owner’smanual.
3
SETUP
1. Position switch under table or on a flat surface considering what side of
the tool you will be working from (table saw – far left, router – far right).
Place switch far enough forward to reach easily but far enough back to
not hit accidentally while using.
2. Mark hole position and set switch aside.
3a. For wood or like materials, drill holes 1/8” diameter x 3/4” deep. Attach
switch to table using #8 x 1” pan head screws provided.
3b. For metal or like materials, drill 3/16” through holes and countersink if
necessary. Attach switch to table using your own hardware.
4. Make sure switch is off before plugging in tool.
5. Plug switch into wall and your tool into switch. Turn switch on when you
are ready and go to work.
OPERATION
Push top of switch to turn switch on or reset switch. Switch will
automatically turn off if overloaded. Push toward the switch box
anywhere on yellow “crash bar” to turn switch off. Feel free to call
RousseauCompanyifyou have any questions.
EXTENSIONCORDS
Use only three-wire grounded cords. For specific size, find the amperage
requiredbyyour power toolandsee chart below.
4
3506REV. 03-05
1718 13th Street Clarkston, WA 99403
800-635-3416 • 509-758-3954 • Fax 509-758-4991
Table of contents
