RS RS406PC-X User manual

www.remotesource.net
RS406PC-X
Six-Circuit-channel Wireless Intelligent Receiver
II. Output Mode
Working temperature:-40℃-+80℃
Frequency: 315MHz, 433MHz(optional)
Voltage: DC12V DC24V(optional)
Contact current:≤10A
Sensitivity:≤-105dBm
Receiver capacity:30(learning code & fixed code)
Size: 113x80x32mm
Static current: ≤8mA
I.Main Technical Param
III. Method & Steps for Learning
Ⅳ. Eliminate stored Information
Ⅴ. Wiring Diagram
A. Press "Learning" button, release it until LED light flickers, Learning light goes out again
and then Receiver in learning status this moment.
B. Press any corresponding button on Remote control. If Learning is accomplished, learning
light on Receiver will flickers 5 times quickly and then exit Learning status. If more than 32s,
still no Learning, Receiver will exit Learning status automatically.
Press "Learning" button for 8s, learning light turns on and then goes out again, that indicates
all stored information has been eliminated.
A. Signal momentary — "Learning" by button 1
B. Signal toggle — "Learning" by button 2
C. Signal latch — "Learning" by button 3
D.3-circuit-channel momentary and 3-circuit-channel
toggle— "Learning" by button 4
learning
button
high receiving plate singlechip
LED light
Ch1
GND V+ NO COM NC NO COM NC NO COM NC NO COM NC NO COM NC NO COM NC
Ch2 Ch3 C h 4 Ch5 Ch6

www.remotesource.net
Ⅳ.Wring Diagram
hight
receiving
plate
relay
bridge
LERAN button
LED light 1 2 3
livewire
AC220V
null line
NO
COM
NC