Rugged Radios RRP665 User manual

Driver PTT used by driver for transmitting over 2-way radio.
VOX control adjusts voice activation sensitivity.
LED green indicates power is on, red indicates transmitting.
VOL / Power controls intercom volume and power.
Passenger PTT used by passenger for transmitting over 2-way radio.
BLUETOOTH pairing mode active when intercom is powered on.
The Remote plugs into the “Remote” port
on the back of the intercom.
+
-
<<
>>
Raises the volume of paired device
Lowers volume
Skips back one track
Skips forward one track
Play/Pause music, answer/end call
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
Power On / Off the intercom by rotating the volume control clockwise / counterclockwise.
Music / Audio input via bluetooth connection.
1 2 3 54 6
RUGGED RRP665 INTERCOM
User Guide
RUGGEDRADIOS.COM RUGGED RRP665 INTERCOM - USER GUIDE V.2020
INTERCOM REMOTE MUSIC CONTROL (OPTIONAL)
INTERCOM OPERATION
Wearing helmets or headsets, rotate the VOX control fully clockwise. This should activate the microphone, allowing you to hear yourself
speak as well as other passengers wearing helmets/headsets. Slowly rotate the VOX control counterclockwise until the microphone turns off.
This setting will have to be adjusted to compensate for background noise. When the VOX is adjusted properly, the microphone should only
be on when speaking. This adjustment also controls music dimming.
The higher the background noise level (engine, wind, etc.), the further counterclockwise you will need to adjust the VOX control.
Be sure to have all helmet / headset microphones positioned so they are touching the lips. This ensures proper micro- phone activation and
promotes noise canceling.
•
•
VOX operation will dim music volume when speaking through the intercom or during radio transmit/receive.
If the music is always quiet, adjust the VOX control on the intercom until the mic turns off and music volume increases.
Only driver can speak on cell phone call.
•
•
•
PTT buttons only activate one microphone (ie: Driver PTT activates Driver microphone). If receiving radios do not hear your voice but hear a
"click" indicating your radio is transmitting, verify that your PTT and headset cables are in the correct ports.
When transmitting the LED on both the intercom and radio will illuminate red.
•
•
VOX ADJUSTMENT
Received audio is controlled by your radio’s volume control, not the intercom volume control. Push-To-Talk (PTT) Buttons are only used for
transmitting over a 2-way radio connected to your intercom. To transmit, press and hold the PTT button, speak, and release when finished.
2-WAY RADIO USE
Start with the intercom powered off and the bluetooth function of your phone or device powered off.
Turn on the intercom.
Turn on the phone or device’s bluetooth.
Wait for “RUGGED 665” to be displayed on the device.
Select “RUGGED 665” and wait for the device to pair to the intercom.
If pairing is not successful, restart the process.
BLUETOOTH PAIRING FOR MUSIC AND CELL

RADIO & INTERCOM MOUNTING CONNECT POWER
RUGGED RRP665 INTERCOM
Installation Guide
RUGGEDRADIOS.COM RUGGED RRP665 INTERCOM - USER GUIDE V.2020
Both the intercom and radio come with universal mounting
brackets. Vehicle specific mounting options are sold separately.
DO NOT mount the radio or intercom near an ignition box to avoid
RF interference.
Route antenna cable away from power leads.
•
•
•
Route all power cables directly to the battery.
DO NOT connect inline with other components. If power is tied to
ignition, lights or other power sources, a ground loop problem may
occur, causing noise in the system.
DO NOT remove any fuses that are in line with factory cables or
otherwise modify power cables.
NOTE: This is a universal wiring diagram. Your exact configuration might vary depending on the system purchased.
•
•
•
RADIO
CO-DRIVER STRAIGHT
CORD PTT
DRIVER COIL
CORD PTT
ANTENNA
If using optional Audio Filter, connect radio
and intercom power leads directly to
Audio Filter and NOT to the battery.
AUDIO FILTER
POWER
RADIO
Connects to optional Radio.
REMOTE
Connects optional controller for
phone/music device. (P.N. RMC-665)
POWER
Connect +/- directly to 12v battery.
HEADSETS
Connects driver and co-driver headsets to
intercom. Route away from power and
antenna cables.
PUSH-TO-TALK
Connects driver and co-driver PTT to
intercom.
CREW HEADSETS
Connects additional headsets to intercom.