Russell Hobbs steam glide User manual

instructions
£10,000 prize draw
PLUS Free Rewards Gallery
Register online now to
collect your reward
See back for
details

2

3
Read the instructions, keep them safe, pass them on if you pass the
iron on. Remove all packaging before use.
AIMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This iron must only be used by or under the supervision of a
responsible adult. Use and store it out of reach of children.
2 Don’t put the iron in liquid, don’t use it in a bathroom,
near water, or outdoors.
3 Route the cable so it can’t be tripped over or caught.
4 Don’t iron clothing while it’s being worn – you’ll burn or scald the
wearer (this is not a joke – I’ve seen it happen).
5 Don’t touch the soleplate, and avoid the steam coming from it.
6 Don’t use the iron in the vicinity of children.
7 Use the iron, or set it on its heel, on a stable, level, heat-resistant
surface, preferably an ironing board.
8 Don’t leave the iron unattended while plugged in, or while it’s
standing on the ironing board. It could be knocked over by you,
by a child, or by a pet.
9 Unplug the iron when not in use, before filling, moving, or
cleaning.
10 Don’t fill the iron directly from the tap, use the jug.
11 Sit the iron upright when you’re not ironing, when it’s cooling,
and when you store it away.
12 Don’t fit any attachment or accessory unless we supply it.
13 Don’t use the iron for any purpose other than those described in
these instructions.
14 Take care not to scratch the soleplate – avoid buttons, zips, etc.
15 The iron has a protective thermal fuse. If it overheats, the iron will
stop working, and must be returned for repair.
16 Don’t use the iron if it’s dropped or damaged, or if it
malfunctions or leaks.
17 If the cable is damaged, return the iron, to avoid hazard.
household use only

4
UBEFORE USING FOR THE FIRST TIME
•Don’t worry if the iron smokes a bit, it’ll stop as the element cures.
•Iron an old piece of cotton fabric, to clean the soleplate.
•Press the Sand *buttons 3 or 4 times, to check them out.
CPREPARATION
1 Check for textile care symbols (ijkl).
2 Iron fabrics at jfirst, then k, and finish with l.
b TEMPERATURE SETTING GUIDE (#2)
label marking dot setting
jcool – nylon, acrylics, polyester •
kwarm – wool, polyester mixtures ••
lhot – cotton, linen •••/max
ido not iron
,If the instructions on the fabric label differ from this guide, follow
the instructions on the label.
XFILLING (#3)
3 In a soft water ares, use tap-water, in a hard water area, use
distilled water (not chemically descaled or softened water).
4 Distilled water must be marketed as suitable for use in irons.
5 Unplug the iron.
6 Set the temperature control to •and the steam control to S(#2).
7 Lift the top of the water inlet cover to open it.
8 Hold the iron with the soleplate level.
9 Pour slowly, or you’ll cause an air lock and the water will overflow.
10 Don’t fill past max, or water will escape in use.
11 Close the water inlet cover, and wipe up any spillage.
CSWITCH ON
12 Set the temperature control to •and the steam control to S(#2).
13 Sit the iron on its heel.
14 Put the plug into the power socket (switch it on, if it’s switchable).
15 The thermostat light will come on.
16 Turn the temperature control to bring the setting you want next
to the 5mark (#2).

5
17 When the iron reaches the temperature you set, the thermostat
light will go off. It’ll then cycle on and off as the thermostat
operates to maintain the temperature.
SSTEAM IRONING
18 Set the temperature control at Sor higher (#2).
19 If you don’t, you’ll get water on your clothes, not steam.
20 Set the steam control at the setting you want, S= no steam, #=
high steam (#2).
21 Wait till the thermostat light goes out, then start ironing.
*SPRAY (#4)
,Test for water spotting on a hidden part of the fabric.
22 You may spray while dry or steam ironing.
23 Check that there’s water in the reservoir.
24 Lift the iron off the fabric, and aim the spray nozzle at the fabric.
25 Press the *button – you may have to press it 2 or 3 times to
pump water through the system.
SSHOT OF STEAM (#5)
26 This works while dry or steam ironing, if there’s water in the
reservoir, and the temperature is above S.
27 Check that there’s water in the reservoir.
28 Check that the temperature control is at Sor higher.
29 Lift the iron off the fabric, and press the #button.
30 It may need 2 or 3 presses to pump water through the system.
31 Leave 4 seconds between shots, to let the temperature build up.
CDRY IRONING
32 If you’re dry ironing for 20 minutes or more, empty the reservoir.
33 Set the steam control to S.
34 Wait till the thermostat light goes out, then start ironing.
CVERTICAL STEAMING (#6)
35 Remove wrinkles from clothes, curtains, and furnishing fabrics.
36 Check there’s ventilation behind the fabric, or mildew may form.
37 Check nothing behind the fabric could be damaged by steam.
38 Check that pockets, turn-ups, and cuffs are empty.

6
39 Check that there’s water in the reservoir.
40 Set the temperature control to max, set the steam control to S.
41 Hold the iron close to (but not touching) the fabric.
42 Press the #button (it’s the shot of steam function used vertically).
43 It may need 2 or 3 presses to pump water through the system.
44 Leave 4 seconds between shots, to let the temperature build up.
CAFTER USE (#7)
45 Turn the temperature control to •, move the steam control to S.
46 Unplug the iron.
47 Lift the top of the water inlet cover to open it.
48 Turn the iron upside down over a sink, and drain the reservoir.
49 Sit the iron on its heel till it’s cold.
50 Close the water inlet cover, and wipe off any moisture.
54 Store the iron on its heel, to avoid corrosion.
CSELF CLEAN (#8)
55 To reduce scale build-up, use the self clean function at least
monthly in normal water areas, more often in hard water areas.
56 You’ll need a basin or a large bowl to catch the water coming out
of the soleplate.
57 Fill the reservoir to the max mark.
58 Set the temperature control to max, set the steam control to S.
59 Sit the iron on its heel.
60 Plug it in, and wait till the thermostat light goes out.
61 Hold the iron over the basin or bowl, with the soleplate down.
62 Press the Cbutton, hold it in, and gently move the iron to and
fro, over the basin or bowl.
caution keep clear of the escaping water and steam
63 Water and steam will wash scale and dust through the soleplate,
and into the sink.
64 When the reservoir is empty, release the Cbutton.
65 Unplug the iron, and sit it on its heel to cool.
66 Wipe off any moisture.
67 Store the iron on its heel, to avoid corrosion.

7
DWIRING INSTRUCTIONS UK plugs only
The product must be earthed. It has a 13A BS1362 fuse
in a 13A BS1363 plug. To replace the plug, fit the green/
yellow wire to Eor E, the blue wire to N, and the
brown wire to L. Fit the cord grip.
If in doubt, call an electrician.
Don’t use a non-rewireable plug unless the fuse cover
is in place. If you remove the plug, dispose of it.
CCLEANING
68 Unplug the iron and let it cool.
69 Wipe outer surfaces with a damp cloth.
70 Remove spots from the soleplate with a little vinegar – take care
not to scratch it.
71 Don’t put the iron in water or any other liquid.
72 Don’t use harsh or abrasive cleaning agents or solvents.
CDESCALING
73 If you live in a hard water area, and you need to descale the iron,
use a proprietary descaler marketed as suitable for irons, and
follow the instructions on the descaler.
74 After descaling, fill the reservoir, and steam iron an old piece of
cloth, to ensure any chemical residues are purged from the iron,
before returning it to normal use.

8
HENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances
marked with this symbol mustn’t be disposed of with
unsorted municipal waste, but recovered, reused, or recycled.
SSERVICE
If you ring Customer Service, please have the Model No. to hand, as
we won’t be able to help you without it. It’s on the rating plate
(usually underneath the product).
The product isn’t user-serviceable. If it’s not working, read the
instructions, check the plug fuse and main fuse/circuit breaker. If it’s
still not working, consult your retailer.
If that doesn’t solve the problem – ring Customer Service – they may
be able to offer technical advice.
If they advise you to return the product to us, pack it carefully,
include a note with your name, address, day phone number, and
what’s wrong. If under guarantee, say where and when purchased,
and include proof of purchase (till receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: [e-mail]
telephone: [phone] (local rate number)
EGUARANTEE
Defects affecting product functionality appearing within two years
of first retail purchase will be corrected by replacement or repair
provided the product is used and maintained in accordance with the
instructions. Your statutory rights are not affected. Documentation,
packaging, and product specifications may change without notice.
IREGISTRATION AND PRIZE DRAW
Collect your free reward, and a chance to win £10,000.
Visit www.productregister.co.uk/rhobbs
551-314