Russell Hobbs Steam Iron User manual

instructions

2

3
Read the instructions, keep them safe, pass them on if you pass the
iron on. Remove all packaging before use.
AIMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of
a responsible adult. Use and store it out of reach of children.
2 Don’t put the iron in liquid, don’t use it in a bathroom,
near water, or outdoors.
3 Route the cable so it doesn’t overhang, and can’t be
tripped over or caught.
4 Don’t iron clothing while it’s being worn – you’ll scald the wearer.
5 Don’t touch the soleplate, keep away from the steam it emits.
6 Don’t use the iron in the vicinity of children.
7 Use the iron, or set it on its heel, on a stable, level, heat-resistant
surface, preferably an ironing board.
8 Don’t leave the iron unattended while plugged in, or while it’s
standing on the ironing board. It could be knocked over..
9 Unplug the iron before filling, before cleaning, and after use.
10 Don’t fill the iron directly from the tap, use the jug.
11 Don’t fill past max, or water may escape in use.
13 Sit the iron upright when you’re not ironing, while it’s cooling,
and when you store it away.
14 Unplug the iron when not in use, before moving and before
cleaning. Let it cool down fully before cleaning and storing away.
15 Don’t fit any attachment or accessory unless we supply it.
16 Don’t use the iron for any purpose other than those described in
these instructions.
17 Don’t scratch the soleplate – avoid buttons, zips, etc.
18 The iron has a thermal fuse, which will blow if it overheats. If this
happens, the iron won’t work, and must be returned for repair.
19 Don’t use the iron if it’s dropped or damaged, or if it malfunctions
or leaks.
20 If the cable is damaged, return the iron, to avoid hazard.
household use only

4
UBEFORE USING FOR THE FIRST TIME
•The iron may smoke a bit at first, it’ll stop as the element cures.
•Iron an old piece of cotton fabric, to clean the soleplate.
•Press the ~button 3 or 4 times, to check it out.
•Press the *button 3 or 4 times, to check it out.
CPREPARATION
1 Check for textile care symbols (ijkl).
2 Iron fabrics needing low temperatures jfirst, then those that
need medium temperatures k, and finish with those needing
high temperatures l.
C TEMPERATURE SETTING GUIDE
label marking dot setting
jcool – nylon, acrylics, polyester •
kwarm – wool, polyester mixtures ••
lhot – cotton, linen/denim •••/max
ido not iron
,If the instructions on the fabric label differ from this guide, follow
the instructions on the label.
CFILLING
3 You may use tap-water, but if you live in a hard water area, use
distilled water (not chemically descaled or softened water).
4 If you buy distilled water, check that it’s marketed as suitable for
use in irons.
5 Unplug the iron.
6 Set the temperature control to •, set the steam control to S.
7 Lift the top of the water inlet cover to open it.
8 Hold the iron so that the water inlet cover is vertical.
9 Pour slowly, to avoid airlocks.
10 Don’t fill past max, or water will escape in use.
11 Wipe up any spillage.
CSWITCH ON
12 Set the temperature control to •, set the steam control to S.
13 Sit the iron on its heel.

5
14 Put the plug into a power socket (switch the socket on).
15 The light will come on.
16 Turn the temperature control to bring the setting you want next
to the 5mark.
17 When the iron reaches the temperature you set, the light will go
off. It’ll then cycle on and off as the thermostat operates to
maintain the temperature.
CREDUCING TEMPERATURE
18 This takes a bit longer, as the iron has to lose the heat it has built
up, so be patient. It’s best to organise your ironing so that you
don’t need to reduce the temperature.
CSTEAM IRONING
19 Set the temperature control to Sor above, otherwise you’ll get
water on your clothes, not steam.
20 Set the steam control to the level you want, S= no steam, #=
high steam.
21 Wait till the light goes out, then start ironing.
*SPRAY
,Water spotting affects some fabrics. Test this on a hidden part of
the fabric.
22 This works with dry or steam ironing, as long as there’s water in
the reservoir.
23 Check that there’s water in the reservoir.
24 Lift the iron off the fabric.
25 Aim the spray nozzle at the fabric.
26 Press the *button – you may have to press it 2 or 3 times to
pump water through the system.
SSHOT OF STEAM
27 This works with dry or steam ironing, as long as there’s water in
the reservoir, and the temperature is above S.
28 Check that there’s water in the reservoir.
29 Check that the temperature control is at Sor higher.
30 Lift the iron off the fabric, then press the ~button

6
31 It may need 2 or 3 presses to pump water through the system.
32 Leave 4 seconds between shots, to let the temperature build up.
CDRY IRONING
33 If you’re going to be dry ironing for 20 minutes or more, empty
the reservoir first, to avoid spontaneous bursts of steam.
34 Set the steam control to S.
35 Wait till the light goes out, then start ironing.
SVERTICAL STEAMING
36 Iron hanging clothes, hanging curtains, and furnishing fabrics.
37 Check that there’s adequate ventilation behind the fabric,
otherwise moisture may build up, causing mildew.
38 Check that there’s nothing behind the fabric that may be
damaged by the steam.
39 Check that pockets, turn-ups, and cuffs are empty.
40 Check that there’s water in the reservoir.
41 Set the temperature control to max, set the steam control to S.
42 Hold the iron just off the fabric, then press the ~button.
44 It may need 2 or 3 presses to pump water through the system.
45 Leave 4 seconds between shots, to let the temperature build up.
CAFTER USE
46 Set the temperature control to •, set the steam control to S.
47 Unplug the iron.
48 Lift the top of the water inlet cover to open it.
49 Hold the iron over a sink, turn it upside down, and drain it.
50 Sit the iron on its heel, and leave it to cool down completely.
51 Wipe off any moisture, and close the water inlet cover.
52 Store the iron on its heel, to avoid corrosion or soleplate damage.
CSELF CLEAN
53 To avoid scale build-up, self clean regularly, at least monthly in
normal water areas, more often in hard water areas.
54 You’ll need a basin or bowl to set below the soleplate.
55 Fill the reservoir to the max mark.
56 Set the temperature control to max, set the steam control to S.

7
57 Sit the iron on its heel.
58 Power the iron up, and wait till the light goes out.
59 Now hold the iron over the basin/bowl, with the soleplate down.
60 Press the Cbutton, hold it in, and gently move the iron to and
fro, over the basin or bowl.
caution keep clear of the escaping water and steam
61 Water and steam will wash scale and dust through the soleplate,
and into the sink.
62 When the reservoir is empty, release the Cbutton.
63 Unplug the iron, and sit it on its heel to cool.
64 When it’s cold, wipe off any moisture.
CANTISCALE
65 The anti-scale agent incorporated in the iron helps prevent the
build-up of scale.
66 Don’t use descaling solution, you’ll destroy the anti-scale agent.
CCLEANING
67 Unplug the iron and let it cool down fully.
68 Wipe outer surfaces with a damp cloth.
69 Remove spots from the soleplate with a dab of vinegar – don’t
scratch it.
70 Don’t use harsh or abrasive cleaning agents or solvents.
DWIRING INSTRUCTIONS UK plugs only
The product must be earthed.
It has a 13A BS1362 fuse in a 13A BS1363 plug. To
replace the plug, fit the green/yellow wire to Eor E,
the blue wire to N, and the brown wire to L. Fit the cord
grip. If in doubt, call an electrician. Don’t use a non-
rewireable plug unless the fuse cover is in place. If you
remove the plug, dispose of it.

8
HENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances
marked with this symbol mustn’t be disposed of with
unsorted municipal waste, but recovered, reused, or recycled.
SSERVICE
If you ring Customer Service, please have the Model No. to hand, as
we won’t be able to help you without it. It’s on the rating plate
(usually underneath the product).
The product isn’t user-serviceable. If it’s not working, read the
instructions, check the plug fuse and main fuse/circuit breaker. If it’s
still not working, consult your retailer.
If that doesn’t solve the problem – ring Customer Service – they may
be able to offer technical advice.
If they advise you to return the product to us, pack it carefully,
include a note with your name, address, day phone number, and
what’s wrong. If under guarantee, say where and when purchased,
and include proof of purchase (till receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: [e-mail]
telephone: [phone] (local rate number)
EGUARANTEE
Defects affecting product functionality appearing within two years
of first retail purchase will be corrected by replacement or repair
provided the product is used and maintained in accordance with the
instructions. Your statutory rights are not affected. Documentation,
packaging, and product specifications may change without notice.
IONLINE
www.russellhobbs.co.uk for more products
551-139