8
OPERATION METHOD
COOLING MODE
• When the A/C enters cooling mode automatically or cooling mode is selected after
power ON, the cooling indicator lamp lights up.
• Press Up/Down key to adjust setting temperature (17°C~30°C).
• Press Speed key to choose High/Mid/Low speed.
FAN MODE
• When pressing mode key or choosing Fan mode by pressing the remote controller, the
wind indicator lamp lights up.
• Press Speed key to choose High/Mid/Low speed.
• Temperature can’t be set.
DEHUMIDIFICATION MODE
• When pressing mode key or choosing dehumidification
mode by pressing the remote controller, the
dehumidification indicator lamp lights up.
• Remove the water wedge and insert a water manifold as
shown in the right figure.
• After entering the dehumidification mode, if room
temperature is ≥15°C, the compressor is ON. Then control as follows: when room
temperature ≤13°C, the compressor is OFF; when temperature increases to
room temperature ≥15°C, the compressor is started again (in order to protect the
compressor, it will be restarted 3min. later).
• In dehumidification mode, the fan is defaulted to run at low speed, and wind speed
can’t be adjusted.
• Temperature can’t be set.
NOTE! When using dehumidify function, the exit pipe components should be removed.
Otherwise it will cause a less satisfying dehumidify performance, and ”FL” (water full
alarm) will appear.
HEATING MODE
• When pressing mode key or choosing heating mode by pressing the remote controller,
the heating indicator lamp lights up.
• Press Up/Down key to adjust setting temperature (17°C~30°C).
• Press Speed key to choose High/Mid/Low speed.
TIMER MODE
• In standby state, press the Timer key to set ON time. Press Up and Down keys to set
ON time (0~24H), and the timer indicator lamp lights up.
• In ON state, pressure the timer key to set OFF time. Press Up and Down keys to set
OFF time (0~24H), and the timer indicator lamp lights up.
ENG
