Rutland county garden furniture Triple bay log store User manual

Triple Bay Log Store –Components

CONTENTS PAGE:



2 X End Panels



3 x back Panels



1 x Base



1 x Lattice



1 x Roof



4 x Centre Posts



65mm Screws



85mm Screws (For the Base only)



2 x Spacer Blocks

Door version only:



3 x Doors



Black Screws (for hinges)



3 x Latches

Firstly, stand the left hand End Panel upright, then place the Back Panel on the two Spacer Blocks provided to give you the

correct distance from the ground. Using the 65mm screws, fix the Back Panel to the Side Panel (as shown in picture 3).

Place one of the longer centre posts next to the Back Panel and using the 65mm Screws, fix into position (as shown in

pictures 1 & 2). Place the next Back Panel on the two Spacer Blocks provided and secure into place using the 65mm Screws.

Repeat this process with the 2nd Centre Post and the 3rd Back Panel.

Slide the base into position and secure using the longer 85mm screws. Screw

into the front posts first and then into the rear, once this has been done,

screw the base into the centre post.

Slide the remaining end panel onto the log store and using the 65mm screws, secure the back panel to the end panel.

Using the 85mm screws, fix the base into position front and rear. Place the roof on top of the posts, ensuring that the roof

support batons finish flush with the front post. Using the 65mm screws, secure the roof into place, front and rear.

Position the lattice as shown in picture 1. Now line up the remaining two

centre posts with the black lines on the base (as shown in picture 2) and fix

into position, ensuring that the centre posts finishes flush with the roof

support batons (as shown in picture 3). Finally lay the lattice down into the

Base Frame.

FINISHED PRODUCT

Door Version Only

Stand the left hand door on a spacer block to give you the correct height, using the 42mm black screws, fix the hinges

into the post on the left, leaving a small gap, as show in pictures 2 and 3. Now repeat the process for the other two

doors ensuring that they open from the middle out (like a wardrobe).

The latches are already screwed onto the front of the doors. Close the doors and hold the latch horizontal, then position

the keeper for each latch and fix into place.