S7 MIG-200 User manual

S7 MIG-200 OPERATION GUIDE

1, ARC Mode
Step.1- Press the blue button below the LCD display to select “STICR”.
Step.2- Adjust the current knob to increase the current.

Step.3- Connect the ground clip and solder handle to the machine.
Step.4- Clamp the ground clamp to the workpiece.

Step.5- The welding handle clamps the electrode, and the welding work start.

2,MIG function
(1) MIG 0.8 Mode（This mode is needed use with carbon dioxide gas and 0.8 solid
wire）
Step.1- Press the blue button below the LCD display to select “MIG 0.8”
Step.2- Adjust the current knob to increase the current

Step.3- Connect carbon dioxide gas
Step.4- Install the welding wire,click the link below to watch the wire installation.
https://www.amazon.com/ask/questions/Tx14BVHOSFNO21R/ref=ask_dp_dpmw_al_hza
*Connect the welding wire to the wire feeding device, pay attention to insert the

welding wire directly into the wire guide tube, and then press the welding wire well.
Step.5-Connect the ground clip and output wire to the machine.
Step.6-Clamp the ground clip to the workpiece, then start your MIG work.

(2) MIG- FLUX 0.8 Mode(Request 0.8 flux cored wire, no need to connect any gas）
Step.1- Press the blue button below the LCD display to select “FLUX 0.8”
Step.2- Adjust the current knob to increase the current

Step.3-Install the welding wire, click the link below to watch the wire installation.
https://www.amazon.com/ask/questions/Tx14BVHOSFNO21R/ref=ask_dp_dpmw_al_hza

*Connect the welding wire to the wire feeding device, pay attention to insert the
welding wire directly into the wire guide tube, and then press the welding wire well.
Step.4- Connect the ground clip and output wire to the machine (Note that the
method of installation is different from that of solid wire, refer to the following figure
to install)

Step.5-Clamp the ground clip to the workpiece, then start your MIG work.
(3) MIG- FLUX 1.0 Mode(Request 1.0 flux cored wire, no need to connect any gas）
* all the step is same as FLUX 0.8 Mode, just request use 1.0 flux cord wire.
3, TIG Mode（Use with Air Cooled Lift TIG Torch)
Step.1- Press the blue button below the LCD display to select “LIFT TIG”

Step.2- Adjust the current knob to increase the current
Step.3-Connect the ground clip and TIG torch to the machine.

Step.4- Put argon gas into the gun trachea
Step.5- Rotate the knob on the TIG torch to adjust the air outlet value

Step.6- The ground clip is fastened to the workpiece and then you can star your TIG
work.