Saab 12 833 679 User manual

Saab 9-3 CV M04-
900 Installation instructions
SCdefault
MONTERINGSANVISNING ·INSTALLATION INSTRUCTIONS
MONTAGEANLEITUNG ·INSTRUCTIONS DE MONTAGE
SITdefault
Saab 9-3 CV M04-
Antenna
Accessories Part No. Group Date Instruction Part No. Replaces
12 833 679 9:39-11 Jun 03 12 833 680
F930A250

2 12 833 680
Saab 9-3 CV M04-
1 Antenna
2 Antenna cable
3Nut
4 Cable tie (x3)
5 Template
F930A251
1
4
35
2

12 833 680 3
Saab 9-3 CV M04-
1 Raise the soft top and open the boot lid.
2 Remove the carpet on the luggage compart-
ment floor and remove the luggage compart-
ment scuff plate.
3 Remove the rivets and lift out the front section of
the luggage compartment trim.
4 Remove the side scuff plate on the right-hand
side.
5 Remove the clips for the right-hand side trim
and fold the trim aside. Unhook the strap on the
rear side of the side trim and remove the side
trim.
4
5
5
5
3
3
3 3
2 2
F930A252

4 12 833 680
Saab 9-3 CV M04-
6US: Remove the emergency opening handle
7 Remove the closing handle on the inside of the
boot lid, the two-stage rivets and the boot lid
trim.
US: Remove the screw for the emergency open-
ing mechanism and move the mechanism aside.
8 Close the boot lid.
F930A253
7
6
77

12 833 680 5
Saab 9-3 CV M04-
9 Cut out the template sections and tape them
together. Align the template sections using the
lines.
Cars with spoiler on the boot lid: Cut out as
indicated by the marking for the spoiler, so that
the template can be positioned flat on the boot
lid.
10 Fit the template onto the boot lid and onto the
front corners of the boot lid.
11 Lift up the template and fit tape where the hole
is to be drilled.
12 Re-align the template and secure with tape to
the sides of the boot lid and the front corners of
the boot lid.
13 Drill the hole as marked.
First drill using a 2 mm bit, then using a 5 mm bit
and finally using a 14 mm bit.
14 Remove the template and all pieces of tape.
15 Deburr the hole and remove loose drillings and
flakes of paint. Clean with Teroson FL Cleaner.
Apply Standox 1K Füllprimer. Apply finish paint.
Apply Terotex HV 400 cavity sealant to internal
surfaces.
Important
Check the position of the template and adjust as
necessary.
Important
Do not use a centre punch to mark the position of
the hole.
Do not press the drill against the boot lid when
drilling.
F930A254
10
13

6 12 833 680
Saab 9-3 CV M04-
16 Remove the plastic guide from the antenna's
threaded sleeve.
17 Guide the antenna cables through the hole in
the boot lid and align the antenna in the longitu-
dinal direction of the car.
18 Fit the antenna.
Tightening torque 2 Nm (1.5 lbf ft)
Note
The base of the interior rear-view mirror can be
used as an alignment guide.
F930A255
18

12 833 680 7
Saab 9-3 CV M04-
19 Fit the kit's antenna cable as follows:
– Guide the antenna cable through the hole in
the boot lid and connect it to the antenna.
– Guide the antenna cable through the hole in
the body and fit the rubber gaiter.
– Guide the antenna cable into the soft top
compartment and down into the luggage
compartment.
– Guide the antenna cable into the torsion com-
partment and forward to the centre of the
torsion compartment.
– Secure the antenna cable to the existing
wiring harness.
Important
Check that the wiring harness rubber gaiter is
fitted correctly at both ends to avoid leakage.
Important
For this to be possible the boot lid must be closed
and the soft top cover open, then close the soft top
cover and open the boot lid.
F930A256
19
19191919 19
19
19
19
19
19
19 19
19
19
19

8 12 833 680
Saab 9-3 CV M04-
20 Align the right-hand side trim and hook on the
strap. Fit the clips.
21 Fit the side scuff plate.
22 Fit the front section of the luggage compartment
trim and the scuff plate. Fit the carpet on the
luggage compartment floor.
F930A257
21
22 22
2020
20
22
22
2222

12 833 680 9
Saab 9-3 CV M04-
23 US: Fit the emergency opening mechanism.
24 Fit the trim on the inside of the boot lid, fit the
two-stage rivets and fit the closing handle.
25 US: Fit the emergency opening handle.
26 Close the boot lid.
F930A258
24
25
23
24