Saeco X-SMALL VAPORE HD8645/47 User manual

Remove the water tank. Rinse tank with water and then fill
with fresh water up to the MAX mark. Place water tank
back into machine. To install water filter see user manual.
NOTE: Only use cool fresh water as any other liquid may
cause damage.
Remove the coffee bean hopper lid and slowly pour beans into hopper and
replace lid.
NOTE: Only use coffee beans. Ground, instant and flavored coffees may
damage the machine.
QUICK START GUIDE
X-SMALL VAPORE
HD8645/47
SET UP
PLEASE NOTE: OUR MACHINES ARE TESTED
WITH COFFEE AT THE FACTORY TO EN-
SURE HIGH QUALITY STANDARDS. WHILE
MACHINES ARE CLEANED THOROUGHLY
AFTER TESTING, IN SOME CASES, COFFEE
GROUNDS MAY REMAIN IN THE MACHINE.
FOR FULL INSTRUCTIONS, PLEASE REFER
TO THE USER MANUAL

1
421944059051
CONTROL PANEL QUICK REFERENCE
Please refer to the control panel reference below for an understanding of functions
18. “Double coffee” light
19. Espresso button
20. Temperature light
21. No water light
22. Coffee button
23. Control dial
24. Warning light
25. ON/OFF button with
machine ready light
Make sure the control dial is on “” position. Press
the “ ” on/off button to turn on the machine; the “ ”
light will begin to fl ash quickly, indicating that the circuit
has to be primed.
BEFORE FIRST USE

1
21 22 23 24 25
18 19 20
TROUBLE SHOOTING
Q: Why is my coffee so weak?
A: The machine automatically adjusts itself after brewing a few cups of cof-
fee to optimize the extraction of the coffee to the compactness of the
ground coffee. We recommend brewing 3-5 espressos before drinking
to allow for this adjustment process. Refer to the "Saeco Adapting Sys-
tem" in the user manual for more information.
A: The coffee may be too coarse. Change the coffee blend or adjust the
grind. Finer coffee grounds result in stronger tasting coffee. Refer to
the “Adjusting the ceramic coffee grinder” in the user manual for more
information.
Q: Why is water/coffee leaking from machine?
A: Sometimes water is drained automatically by the machine into the drip
tray to manage the rinsing of the circuits and ensure optimum machine
performance.
A: The dispensing spout may be clogged. Clean the dispensing spout holes.
Q: Why isn’t the machine filling up my cup?
A: The machine’s coffee lengths can be programmed. For details on how
to do this please refer to the user manual.
For more troubleshooting please refer to the User Manual.
NEED ASSISTANCE:
If you have any questions or concerns, we are always available to assist you.
Please call us direct at 1-800-933-7876
or visit us at www.philips.com/saeco

2
9/2015
421944059051_HD8645_47_QSG.indd 1 9/3/2015 7:42:13 PM


1

1Place an espresso cup under the dispensing spout.
BREWING TWO ESPRESSOS USING WHOLE BEANS
Place two espresso cups under the dispensing spout.
Place a container under the steam wand then turn the control
dial to the “” position.

2

3

4

5
Once heated, a 1-minute rinse/self-cleaning cycle with fresh water will begin
automatically. Place a container under dispensing spout to catch water.
Before using the machine for the first time a manual rinse
cycle must be initialized. Place a container under the steam
wand then turn the control dial to the “” position. The
“” light fl ashes slowly and water will start to dispense.
Dispense all water until the " " light is illuminated and then
refi ll the water tank.
When water dispensing stops, the “” light flashes slowly. Turn the control dial
to the “ ” position.The machine is now in warm-up mode and the “ ” light will
fl ash slowly.
BREWING AN ESPRESSO USING WHOLE BEANS

2Press the “” button to start brewing.

2To brew two espressos press the “” button twice
consecutively and the machine will begin brewing.
NOTE: Brewing two espressos requires two grinding and
brewing cycles, automatically carried out by the machine.

1

4

2

3
HOW TO FROTH MILK USING THE STEAM WAND
Fill a frothing pitcher 1/3 of the way with cold milk.
Immerse the steam wand into the milk. Turn the control
dial to the " " position.
NOTE: Steam will begin dispensing when the machine
reaches the optimum temperature.
Froth the milk by gently swirling the container and moving it up and
down. When the milk froth has reached your desired consistency,
turn the control dial back to the “ ”position to stop steam dispensing
and end the process.
After each use, clean the steam wand as described in the user manual.

1

2

4

3
Fill the water tank again up to the MAX level indicator.
Place a cup under the dispensing spout. Make sure the control dial is set to the
“ ” position then press the “” button to grind and dispense espresso.
Repeat Step 2 three-five times.
Your machine is now ready to brew coffee!
OPTIMIZE YOUR COFFEE
To optimize the extraction of coffee to the compactness of the ground coffee, brew
3-5 cups of espresso BEFORE drinking.
421944059051_HD8645_47_QSG.indd 2 9/3/2015 7:42:14 PM