Safe-Strap SAFE-DOCK User manual
SAFE-DOCKTM Replacement Harness Instructions
Please Read All Instructions Before Beginning the Installation.
Tool Needed: Phillips Screwdriver
Step 5
At Least Monthly...
Inspect Safe-Dock for damage
Check all fasteners for tightness to ensure safety
Clean Safe-Dock with mild detergent and a damp cloth
Step 4
Step 1
Prop shopping cart gate into
its raised position as shown
using a screwdriver or piece of
wood.
Step 2
Step 3
SAFESTRAP.COM 800.356.7796 973.442.4623 [email protected]
Find the two screws that se-
cure the harness to the Safe-
Dock. Remove the screws
and the metal plate. Do the
same on the other side.
Keep the screws and metal
plates for attaching the re-
placement harness.
Pull the old harness through
the holes in the Safe-Dock.
Discard.
Insert one end of the replace-
ment harness into the harness
receiving slot.
Lay the replacement harness out on the Safe-Dock.
The red release button should point towards the
handle of the shopping cart.
• Tighten all 4 screws.
Secure by inserting the metal
plate into the harness’s end
loop. Do the same on the other
side.
• Secure the metal plate
to the Safe-Dock using the
screws from Step 1.
• Repeat on other side.
rev: 2016/01-cjf
©Copyright 2016 Safe-Strap Company, LLC. All rights reserved.
Shopping Cart Infant Docking Station Safety Inspection
Inspecting your Safe-Dock shopping cart infant docking stations are necessary to keep them in proper
working order. To assist in your Safety Inspection Program, please use the following Safety Inspection
Checklist for shopping cart infant docking stations.
The Safe-Dock should be inspected frequently on a daily basis to identify problems. Have staff famil-
iarize themselves with the Safe-Dock and what to inspect daily.
Shell:
1. Warning label is present and fully legible.
Harness and Webbing:
1. No sign of visible fraying
2. Free of rips and tears
3. Free of excessive wear
4. All stitching visibly intact
5. No loose or pulled threads
Buckles:
1. No sign of visible wear
2. No cracks, breaks, or missing halves/parts
3. Buckle functions properly when buckled and released (fasten the buckle, and pull the mating
ends of the belt - if buckle unfastens, replace the belt - if buckle can’t be unbuckled, replace
the belt)
Frame:
1. Frame is anchored securely to the shopping cart with all 4 nuts fastened tightly.
2. There are no cracks or protruding areas on the units that may cause injury.
Over-all Appearance:
1. No signs of excessive wear, fading, stains, or damage.
2. Clean inviting appearance.
Care and Maintenance Information:
1. Clean unit as often as needed using a mild soap or detergent.
2. Make sure all cleaning agents have been completely removed from the unit prior to putting it
back into service.
3. Parts such as the safety harnesses can be replaced easily. Other repairs may require a higher
level of mechanical expertise.
4. Please call 973.442.4623 for replacement parts.
A SAFE-DOCK that fails any of these inspection checks or is not installed consistent with
SAFE-STRAP Company, Inc.’s Shopping Cart Infant Docking Station Instructions should be
replaced.
SAFESTRAP.COM 800.356.7796 973.442.4623 [email protected]
rev: 2016/01-cjf
©Copyright 2016 Safe-Strap Company, LLC. All rights reserved.
