SafeDial Wireless GL45-4G User manual

This guide provides step-by-step instructions, with simple explanations to get you up and running.
For further information, please go to WWW.GLOBEWIRELESS.COM.AU
STEP 1 – ACTIVATE - Flip over this pamphlet for details
STEP 2 – WIRE - As per the diagram
STEP 3 – SEND AN EVENT - Trigger an event from the Alarm Panel
The GL45 obtains the Account Code directly from the Alarm Panel during the first alarm event
STEP 4 – CONTACT CONTROL ROOM – Confirm your event was received
ALL DONE
ACTIVATE ONLINE – SAVE TIME!
R1 T1R T –
– Rx Tx +
1 2 3 1 2 3
OUTPUT INPUT
DIRECT WIRING IS
RECOMMENDED
Typical Keyswitch
wiring for use with
Pocket Secure
Dialler
Power
12V Z Z Z CCC
**Make sure you have a common ground between the GL45 and the Alarm Panel**
For direct wiring or keyswitch wiring and
programming for various alarm panels, please refer to
www.globewireless.com.au/technical-support/
OUT - YELLOW
IN - GREEN
IN - RED
OUT - BLACK
QUICK START GUIDE
https://safedial.permaconn.com

ACTIVATE DEVICE CREATE POCKETSECURE USER
CLICK FLEET CLICK USERS
CLICK CREATE USER
ENTER END USER DETAILS
NB: Password must be at least 8 characters, with 1 capital & one number
ADD DEVICE
NB: Type the Serial Number into the text box at the top and click on the grey box that opens below.
ENTER SERIAL NUMBER
ADD SITE DESCRIPTION
SELECT YOUR 1345 NUMBER (if applicable)
CLICK ACTIVATE NEW PERMACONN
CLICK ACTIVATE
If the device is already powered
up power cycle for faster
network registration
Log into SafeDial Toolbox to ACTIVATE devices
and CREATE PocketSecure users
https://safedial.permaconn.com
1300 737 314
NOTE: An SMS with instructions
will be sent to your customer