Saferhomee HB-4040S User manual

Wireless Alarm Receiver
User Manual

Indicator Light
Speaker
Backup Battery
Compartment
1
1. Configuration List
2. System Components And Usage
1 piece (includes 1 power adapter)
1 piece
Wireless Alarm Receiver
English Manual
Wireless Alarm Receiver
Indicator Light: Will be red if power on;Will flash if on setting mode
Speaker: Will alarm for several seconds if the sensor be triggered
Backup Battery Compartment:4 pieces AA 1.5V batteries(can keep the wireless alarm receiver
working continuously for 100 hours if AC power off)
After-sale Service E-mail:[e-mail]

2
ADD
3. Operation Instructions
Power : power jack(DC5V)
ON/OFF: power switch(turn on/off the wireless alarm receiver)
set button(add/delete the sensors of the wireless alarm receiver)
Tone: Choose the ring tones(total 35 ring tones optional)
Volume:Press and hold the“ON/OFF”button first,and then press
the“Tone”button to adjust the alarm volume,total 4 volume levels.
Power
ON/OFF
Tone
(1)How to add sensors to the wireless alarm receiver
Step 1
Power on the by the power adapterwireless alarm receiver
(up to 32 sensors can be added to the receiver)
Power

stop flashing
ON/OFF
flashing
release the button
Step 2
Press and hold the “ON/OFF” button for 5 seconds and release the button when
the indicator light flashing;
Step 3
Trigger the sensor(for example,trigger the solar&wireless photoelectric beam sensor)
(a ring tone prompt and the indicator light stops
flashing means the sensor has been added to
the wireless alarm receiver successfully)
Step 4
Trigger the again to confirm the sensor has been added to the wireless alarm
receiver already.
sensor
3
ON/OFF
light up
press and hold the ON/OFF button
for 5 seconds

(3)How to adjust the alarm volume
Tone
(2)How to delete the sensors of the wireless alarm receiver
Step 1
Power on the wireless alarm receiver by the power adapter
Step 2
Press and hold both the “ON/OFF” button and “Tone for 10 seconds and release
the buttons when you heard a long bleep;
Note: all the sensors will be deleted by this operation;
”button
ON/OFF
Tone
4
Step 5
“ ”button to choose the ring tone for this , there are 35 tones
to choose from;
Press Tone sensor
Step 1
Power on the wireless alarm receiver by the power adapter
Step 6
Press and hold the“ON/OFF”button first,and then press
the“Tone”button to adjust the alarm volume,
total 4 volume levels.
ON/OFF
Tone
Adjust the alarm volume.

Static Current 20mA; Alarming Current 300mA
Working Current
DC5V
433MHz FSK+FHSS
Technical Parameters
Working Voltage
Wireless Frequency
Backup Battery
Item
5. Technical Parameters
162mm
52mm
Technical Parameters
4 pieces AA 1.5V batteries(package is not included)
4040S20190116-03
ON/OFF
Tone
Step 2
Press and hold the“ON/OFF”button first,and then press the“Tone”button to
adjust the alarm volume,total 4 volume levels
(4)How to change the ring tone for the sensors
Step 1
Power on the wireless alarm receiver by the power adapter
Step 2
Trigger the sensor first,and then press the "Tone" button to
choose the ring tone for this sensor;
Same steps for other sensors which have been added to
the wireless alarm receiver already.
5
After-sale Service E-mail:[e-mail]