Sage Smart Scoop BCI600 User manual

EN QUICK GUIDE DE KURZANLEITUNG
FR GUIDE RAPIDE NL SNELSTARTGIDS
ES GUÍA RÁPIDA IT GUIDA RAPIDA
PT MANUAL RÁPIDO
BCI600/SCI600
the Smart Scoop™

2
CONTENTS
2Important Safeguards
5Features of Your New Appliance
6Components
8Operation
10 Care & Cleaning
11 Troubleshooting
13 Guarantee
SAGE®
RECOMMENDS
SAFETY FIRST
At Sage®we are very safety
conscious.We design and
manufacture consumer
products with the safety of
you, our valued customer,
foremost in mind. In addition
we ask that you exercise a
degree of care when using
any electrical appliance
and adhere to the following
precautions.
WARNING
To prevent damage to the
compressor and to ensure
maximum performance,
place unit in an upright
position for 12 hours after
transit and before use.
NOTE
Always store the ice cream
machine upright and level on its
supporting feet. This will ensure
reliable compressor performance.
IMPORTANT
SAFEGUARDS
READ ALL INSTRUCTIONS
BEFORE USE AND SAVE
FOR FUTURE REFERENCE:
• A downloadable version of
this document is also available
at sageappliances.com
• Before using the rst time ensure
your electricity supply is the
same as shown on the label on
the underside of the appliance.
This appliance is equipped with
a power cord having a grounding
wire with a grounding plug.The
appliance must be grounded
using a properly grounded outlet.
In the event of an electrical fault,
grounding reduces the risk of
electrical shock.
• Remove and safely discard
any packaging materials before
rst use.
• To eliminate a choking hazard
for young children, safely
discard the protective cover
tted to the power plug.
• This appliance is for household
use only.Do not use the appliance

3
EN
WE RECOMMEND SAFETY FIRST
for anything other than its intended
use.Do not use in moving vehicles
or boats.Do not use outdoors.
Misuse may cause injury.
• Fully unwind the power cord
before operating.
• Position the appliance on a
stable, heat resistant, level, dry
surface away from the edge and
do not operate on or near a heat
source such as a hot plate, oven
or gas hob.
• Vibration during operation may
cause the appliance to move.
• Do not let the power cord hang
over the edge of a bench or
table, touch hot surfaces or
become knotted.
• Always ensure the appliance
is turned OFF, unplugged at
the power outlet and has been
allowed to cool before cleaning,
attempting to move or storing.
• Always turn the appliance to the
OFF position, switch o at the
power outlet and unplug at the
power outlet when the appliance
is not in use.
• Do not use the appliance if the
power cord, plug, or appliance
becomes damaged in any way. If
damaged or maintenance other
than cleaning is required, please
contact Sage Customer Service
or go to sageappliances.com in
order to avoid a hazard.
• Any maintenance other
than cleaning should be
performed by an authorised
Sage service centre.
• Children should not play
with the appliance.
• Cleaning and user maintenance
of the appliance should not be
carried out by children unless
they are 8 years or older
and supervised.
• The appliance and its cord
should be kept out of reach
of children aged 8 years
and younger.
• The installation of a residual
current safety switch is
recommended to provide
additional safety when using
all electrical appliances.
Safety switches with a rated
operating current not more
than 30mA are recommended.
Consult an electrician for
professional advice.
• Always ensure the appliance is
properly assembled before use.
• Do not use the appliance
on a sink drain board.
• Keep hands, ngers, hair,
clothing as well as spatulas and
other utensils away from moving
or rotating parts during operation.
• Do not use the appliance for
anything other than food and/or
beverage preparation.

4
WE RECOMMEND SAFETY FIRST
• In order to avoid the possible
hazard of the appliance starting
by itself due to inadvertent
resetting of the overload
protection, do not attach
an external switching device
(such as a timer) or connect
the appliance to a circuit
that can regularly switch the
appliance on and o.
• Carefully read all instructions
before operation and save for
future reference.
• The appliance can be used by
persons with reduced physical
or mental capabilities or a lack
of experience and knowledge,
only if they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved.
• The appliance can be used by
children aged 8 years or older if
they have been given supervision
or instruction concerning use
of the appliance in a safe way
and if they understand the
hazards involved.
• Position the appliance at a
minimum distance of 15cm
away from walls to ensure
proper ventilation.
• Do not cover the air vents when
the ice cream machine is in use.
• Do not place any ingredients
directly into the ice cream
chamber. Place ingredients
into the ice cream bowl only.
• Do not store explosive
substances such as aerosol
cans with a ammable
propellant in this appliance.
• Do not leave the lid o the ice
cream machine for extended
periods of time. Do not use any
other accessories other than
those provided with the product.
The symbol shown
indicates that this appliance
should not be disposed of
in normal household waste.
It should be taken to a local
authority waste collection centre
designated for this purpose or to
a dealer providing this service.
For more information, please
contact your local council oce.
To protect against electric
shock, do not immerse the
power plug, cord or appliance in
water or any liquid.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS

5
EN
FEATURES OF YOUR NEW APPLIANCE
Automatic Mode
Automatic mode churns and freezes the
ingredients to the selected/desired consistency.
Select one of the four pre-set functions:Sorbet,
frozen yogurt, gelato or ice cream.Smart Scoop
will beep when ready.
Manual Mode
The time to make ice cream can be manually set
for pre-timed recipes.
Preset Functions
The Sage®Smart Scoop™has four pre-set
functions to pick from. Select one of the following
settings; sorbet, frozen yogurt, gelato, or ice cream.
Pre-Cool
It’s good practice to pre-cool the machine when
preparing your dessert base.This optional function
will cool the machine to approximately -10 to -30°C
and usually take about 5–10 minutes.
Keep Cool
Once the consistency of the dessert has been
achieved, Keep Cool will prevent the mixture from
melting for up to 3 hours.When the machine is in
this mode, note that the compressor will operate
intermittently to ensure consistency of the dessert.
Child Lock
The Sage®Smart Scoop™features a child lock.
Press and hold HOLD for 2 seconds to set the
child lock mode.To exit this mode press and hold
for 2 seconds again.
Add Mix-Ins
Mix-ins such as chocolate chips, fresh fruit and
avours can all be added easily through the ip
back lid.The ice cream machine will beep and
ADD MIX-INS will ash to let you know that it is
time to add your favourite condiments!
Sound
The ice cream machine features an alert beeper
when your ice cream is ready.This alert can be
set between: loud, soft or mute.

6
COMPONENTS
A B C G H I
EJ
F
K
L
D
C
N
M
A. Anodised ice cream bowl
Not dishwasher safe and should not be stored
in the freezer.
B. Paddle
C. Lid
D. Stainless steel housing
E. POWER
F. START / PAUSE
G. Manual timer
H. PRE-COOL function
I. Keep cool
J. Auto timer/Hardness selection dial
Will scroll between the following settings:
sorbet, frozen yogurt, gelato, or ice cream.
Rotate the dial left for softer textured desserts
or right for harder textured desserts.
K. TEMP / UNITS button
Allows you to toggle between Celsius and
Fahrenheit.
L. Sound
Select between loud, soft or mute.
M. Handles
N. Bowl chamber
Rating Information
220–240V~ 50Hz 170–200W

7
EN
COMPONENTS
W
Y
X
Z
TPQ
R
U
V
S O
SMART SCOOP DISPLAY
O. LCD Control Display
P. Hardness selection bar
Q. Progress indicator bar
R. Keep Cool will keep the frozen dessert chilled
and churned for up to 3 hours.
S. Add mix-ins will ash to let you know when
it is time to add your favourite mix-ins.
T. Pre-Cooling
Pre-cool works by reducing the temperature
of the cooling chamber to its optimal operating
temperature before the base mix is introduced.
As the appliance is already cold it will take
less time to freeze.This reduces the churning
required to achieve the dense & creamy
consistency of a great gelato.
U. Press Start ashes when in the PRE-COOL
mode to advise that the machine is chilled
and ready to start churning.
V. Remove blade indicates that the dessert is
nished and the blade can be removed from
the bowl.
ACCESSORIES
W. Anodised ice cream bowl
X. Spatula use to scrape the bowl
Y. Paddle
Z. Bottle brush for easy cleaning of the paddle
and bowl

8
OPERATION
BEFORE FIRST USE
Machine preparation
Remove and discard all labelling and packaging
materials attached to your ice cream machine.
Ensure you have removed all parts and
accessories before discarding the packaging.
Remove the lid, ice cream bowl and paddle from
the machine. Clean these parts and accessories
using warm soapy water and rinse thoroughly.
Ensure all parts are completely dry.
FIRST USE
Initial start up
• Place paddle inside the bowl.
• Place ingredients inside the bowl in order
of the recipe.
• Place ice cream bowl into the ice
cream chamber.
• There are 2 grooves in the bowl chamber.
When positioning the bowl, align so that the
bowl handle hinge is positioned within these
grooves.
• Make sure the BOWL CHAMBER and the
exterior of the ice cream bowl is completely
dry before inserting.
1. To lock the lid into position, align the lid
handle to the alignment graphic, rotating
clockwise into the LOCK position.
2. Press the POWER button to turn the
machine on.
3. Rotate the hardness selection dial to your
chosen dessert.
Press the START / PAUSE button to begin
the churning process.The elapsed time will
be displayed on the LCD.
4. The smart scoop will beep when your
dessert has reached its desired consistency.

9
EN
OPERATION

NOTE
PRE-COOL can only be operated
in the stand by mode, before
pressing START / PAUSE button.
a) PRE-COOL lowers the temperature of the
ice cream machine to reduce the time it
takes to prepare your dessert. It is optional
and is ideal to use while you are preparing
your ice cream base before churning.
b) To select PRE-COOL function, press the
PRE-COOL button.The light surrounding
the button will turn from white to red
to indicate that the machine is in
PRE-COOL mode.
This mode will ‘PRE-COOL’ the machine
to approximately -10°C to -30°C, taking
about 5-10 minutes. READY will illuminate
and PRESS START will ash on the LCD
screen when the ice cream maker has
reached optimal temperature.
The paddle will start turning after
15 minutes has passed, but will not start
making the frozen dessert unless the
START / PAUSE button is pressed.
In this function, the LCD screen will display
the temperature, PRE-COOLING will
illuminate and the progress indicator
will scroll, to let you know that you are
in this mode.
c) PRE-COOL will return to standby
after 20 minutes or alternatively can
be switched o either by pressing
PRE-COOL button again or pressing
the START / PAUSE button which will
override the pre-cooling mode.
NOTE
START / PAUSE button will have
to be pressed to start the churning
process after pre-cooling.

10
CARE & CLEANING
Ensure that the ice cream machine is turned o
by pressing the POWER button.The ice cream
machine is o when the START / PAUSE button’s
LED light is no longer illuminating red. Remove
the power plug from the power outlet. Allow the ice
cream machine compressor to cool completely
before disassembling and cleaning.
CLEANING THE STAINLESS
STEEL HOUSING
1. Wipe the exterior of the stainless steel
housing and the LCD screen with a soft
damp cloth. Do not use a dry paper towel
or cloth to clean the LCD screen, or use an
abrasive cleanser or metal scouring pad to
clean any part of the ice cream machine as
these will scratch the surface.
NOTE
Never immerse the stainless steel
housing in water or place in the
dishwasher. Take care not to allow
water or cleaning uids to seep
under the buttons or LCD screen
on the control panel.
NOTE
To clean the ice cream chamber
ensure that the unit is at room
temperature. Wipe out with soapy
water and a soft damp cloth.
2. If over-spill of cream, milk, chocolate etc.
occurs in the interior chamber, carefully
remove using a soft, damp cloth.
3. Let all surfaces dry thoroughly prior to
inserting the power plug into a power outlet.
CLEANING THE LID
The lid can be cleaned in warm soapy water, using
a soft sponge. Do not use an abrasive cleanser
or metal scouring pad as these will scratch the
surface.Let all surfaces dry thoroughly prior to
placing into the ice cream machine.
CLEANING THE ICE CREAM BOWL
Fill the ice cream bowl up halfway with warm
soapy water.A non-abrasive liquid cleanser or
mild spray solution may be used.Allow to stand
for 10-20 minutes.
NOTE
Ice Cream Bowl is NOT
dishwasher safe.
CLEANING THE PADDLE
1. Wash the paddle with warm soapy water.
Using the bottle brush supplied insert this
in the central part of the paddle to clean all
the ice cream out.
2. Let all surfaces dry thoroughly before
reassembling the ice cream machine.
NOTE
Paddle and lid are dishwasher safe
on the top rack ONLY.
STORAGE
Store the appliance in an upright position and level
on it support legs. Do not store anything on top
of the ice cream machine.