Sailor 6217 VHF User manual

What’s in the box?
How to install the VHF on desktop and overhead
How to install the VHF flush mount
INSTALLATION GUIDE
SAILOR 6217 VHF DSC - AIS Receiver
Drilling plan on desktop and overhead
99-130249
4 x M4 or hole for
self-tapping ø3.9
150mm
53mm
71mm
196mm
23mm
9mm
Tilting ±20°
Note!
- Firmly tie back and secure any wires not used in order to
avoid possibility for mutual shorting or shorting to ground!
- To ensure waterproof sealing:
If the surface isn’t plane and/or rigid remove the gasket and
seal with silicone sealant between the VHF and the surface.
U-Mounting
Bracket
Transceiver Gasket
Flush Mount
Bracket (2 pcs.)
Sun Screen
Fuse
6.3x3.2mm (10AT)
Hand Microphone
Cradle
Wheel Knob
(2 pcs.)
Screw M4x45
TORX 20
(5 pcs.)
Square Nut
M4x7x2.2
(5 pcs.)
Screw M4x12
TORX 20 (3 pcs.)
Screw ø3.9x19
TORX 20 (3 pcs.)
Screw M4x12
TORX 20
(5 pcs.)
Screw ø3.9x19
TORX 20
(5 pcs.)
Power CableConnection Cable,
1 m
Cable assembly for waterproof installation
1.
2.
3.
4.
Connect the 4 cable connections with rubber vulcanizing tape as shown .....
Cap for LTW BD/BU
Connector
(2 pcs.)
What’s in the box?
How to install the VHF on desktop and overhead
How to install the VHF flush mount
INSTALLATION GUIDE
SAILOR 6217 VHF DSC - AIS Receiver
AA
B B
99-130248
Gasket
FlushMount Bracket (2 pcs.)
ScrewM4x45 TORX 20 (4 pcs.)
Connectto LOUD HAILER
(REDisolation on inner connector)
Connectto EXT. SPEAKER
(WHITEisolation on inner connector)
Connectto POWER +
(REDwire)
Connectto POWER -
(BLUEwire)
SquareNut M4x7x2.2 (4 pcs.)
Maxwall thickness 26mm
Drilling plan on desktop and overhead
Very important information!
99-130249
4x M4 or hole for
self-tappingø3.9
150mm
53mm
71mm
196mm
23mm
9mm
Tilting ±20°
Do not remove the membrane.
If you remove the membrane the radio will not be waterproof.
Note!
- Firmly tie back and secure any wires not used in order to
avoid possibility for mutual shorting or shorting to ground!
- To ensure waterproof sealing:
If the surface isn’t plane and/or rigid remove the gasket and
seal with silicone sealant between the VHF and the surface.
U-Mounting
Bracket
Transceiver Gasket
Flush Mount
Bracket (2 pcs.)
Sun Screen
Fuse
6.3x3.2mm (10AT)
User & Installation Manual
Hand Microphone
Cradle
Wheel Knob
(2 pcs.)
Screw M4x45
TORX 20
(5 pcs.)
Square Nut
M4x7x2.2
(5 pcs.)
Screw M4x12
TORX 20 (3 pcs.)
Screw ø3.9x19
TORX 20 (3 pcs.)
Screw M4x12
TORX 20
(5 pcs.)
Screw ø3.9x19
TORX 20
(5 pcs.)
USER&INSTALLATIONMANUAL
SAILOR6217VHFDSC-AISReceiver
Power CableConnection Cable,
1 m
Cable assembly for waterproof installation
1.
2.
3.
4.
Connect the 4 cable connections with rubber vulcanizing tape as shown .....
Membrane
Cap for LTW BD/BU
Connector
(2 pcs.)
Brown,Pin 1, NMEA in+
Blue,Pin 2, NMEA in-
Forwaterproof installation use
rubbervulcanizing tape
White,Pin 3, NMEA out-
Green,Pin 4, NMEA out+
GPSCable (NMEA 0183)/
ChartPlotter Cable
ChartPlotter
GPS
99-131043-B
Note!
Firmly tie back and secure any wires not used in order to avoid
possibility for mutual shorting or shorting to ground!
Pinassignments
FrontView
Wirecolor Pin
Brown 1
Blue 2
White 3
Green 4
Yellow 5
Grey 6
Pink 7
Red 8
1
2 9
8
7
6 103
4 5
Black 9
10 Orange-SCREEN (Drain)
NMEAin+
NMEAin-
NMEAout-
NMEAout+
Mike2/ Line in
EAR2/ Line out
Hook_PTT
BatterySupplywhen radio is on
InternalGND= - Battery
InternalGND= - Battery
Description
99-130891-B
How to install the GPS and the Chart Plotter - Cable connections
Pinassignments
FrontView
Wirecolor Pin
Brown 1
Blue 2
White 3
Green 4
Yellow 5
Grey 6
Pink 7
Red 8
1
2 9
8
7
6 10 3
4 5
Black 9
10 Orange- SCREEN (Drain)
NMEAin+
NMEAin-
NMEAout-
NMEAout+
Mike2 / Line in
EAR2 / Line out
Hook_PTT
BatterySupply when radio is on
InternalGND = - Battery
InternalGND = - Battery
Description
99-130891-B
Installation Guide
User & Installation Manual
USER& INSTALLATION MANUAL
SAILOR 6217VHF DSC - AIS Receiver
Very important information!
Do not remove the membrane.
If you remove the membrane the radio will not be waterproof.
Membrane
How to prevent water ingress
Connector for Hand Microphone or Handset - If not used, put the cap
from the ACC connector on the front connector to prevent water ingress.
Dimensions for the VHF
AA
B B
99-130248
Gasket
Flush Mount Bracket (2 pcs.)
Screw M4x45 TORX 20 (4 pcs.)
Connect to LOUD HAILER
(RED isolation on inner connector)
Connect to EXT. SPEAKER
(WHITE isolation on inner connector)
Connect to POWER +
(RED wire)
Connect to POWER -
(BLUE wire)
Square Nut M4x7x2.2 (4 pcs.)
Max wall thickness 26mm

Flush mount template
Remove material from shaded area only!
99-129294
89mm
177mm
R2.5mm x 4
[e-mail] •thrane.com
98-130638-THR-D
Handset
Microphone
AIS Receiver
GPS in (NMEA 0183)
Cable
Service
Loud Hailer (4 ohm)
Speaker (8 ohm)
External
ACC. Port
Power
Handset Option
SAILOR 6205
SAILOR 6201
SAILOR 6201
99-129890-D
VHF DSC -
Hand Microphone
SAILOR 6202
12V DC
110/220V AC
GPS
GPS,
Control Speaker
SAILOR 6207
Connection Box
for parallel handsets
SAILOR 6217
CTRL
ACC
Chart Plotter
N163S
Aerial
RX/TX
SAILOR 6090
12V Battery
24V DC
Power Converter
Cutout for flush mounting of the VHF System Configuration - Example
Dimensions for Hand Microphone - how to install the cradle Accessorie - SAILOR 6205 Control Speaker Microphone
Cradle
99-129296
2 x M4 or hole for
self-tapping ø3.9
34.6mm 46.8mm
28.5mm
Scale 1:1
IMPORTANT!
If this template was printed from an electronic
file or copied, scaling (1:1) may not be correct.
Consequently do not attempt to use a printed
or copied template without prior checking of
dimensions.
Cradle
Note!
Firmly tie back and secure any wires not used in order to avoid
possibility for mutual shorting or shorting to ground!
Pin assignments
Front View
Wire color Pin
Brown 1
Blue 2
White 3
Green 4
Yellow 5
Grey 6
Pink 7
Red 8
1
2 9
8
7
6 10 3
4 5
Black 9
10 Orange - SCREEN (Drain)
NMEA in+
NMEA in-
NMEA out-
NMEA out+
Mike 2 / Line in
EAR 2 / Line out
Hook_PTT
Battery Supply when radio is on
Internal GND = - Battery
Internal GND = - Battery
Description
99-130891-B
How to install the GPS and the Chart Plotter - Cable connections
Pin assignments
Front View
Wire color Pin
Brown 1
Blue 2
White 3
Green 4
Yellow 5
Grey 6
Pink 7
Red 8
1
2 9
8
7
6 10 3
4 5
Black 9
10 Orange - SCREEN (Drain)
NMEA in+
NMEA in-
NMEA out-
NMEA out+
Mike 2 / Line in
EAR 2 / Line out
Hook_PTT
Battery Supply when radio is on
Internal GND = - Battery
Internal GND = - Battery
Description
99-130891-B
For further information, please download the installation
manual part no. 98-135548 at http://esupport.thrane.com
Brown, Pin 1, NMEA in+
Blue, Pin 2, NMEA in-
For waterproof installation use
rubber vulcanizing tape
White, Pin 3, NMEA out-
Green, Pin 4, NMEA out+
GPS Cable (NMEA 0183)/
Chart Plotter Cable
Chart Plotter
GPS
99-131043-B