SAINT-GOBAIN Solar Gard Computer Cut User manual

ASSEMBLY AND INSTALATION
REVOLVER FILM LOADER
1. 2 SUPPORT ARMS
2. 1 LEFT SPINDLE
3. 1 RIGHT SPINDLE WITH SPRINGS
4. 4 SUPPORT ARM SCREWS
5. 5 LOCKING NUTS
6. 1 DOG BONE ARM
7. 1 SPINDLE ROD
8. 1 ALLEN WRENCH
PARTS LIST
11
23
4
5
6
7
8

REVOLVER FILM LOADER ASSEMBLY AND INSTALATION
ATTACH LEFT AND RIGHT SUPPORT
ARMS TO THE PLOTTER WITH THE
SUPPORT ARM SCREWS.
PLACE LEFT SPINDLE ON SPINDLE
ARM. LEFT SPINDLE IS NOT
SPRING LOADED.
SET LOCK NUT ON
LEFT SPINDLE.

REVOLVER FILM LOADER ASSEMBLY AND INSTALATION
ATTACH DOG BONE ARM
TO SPINDLE ARM WITH THE
COUNTERSINK FACING LEFT.
THIS ACCESSORY IS USED FOR
HOLDING ROLLS SMALLER THAN
40” IN WIDTH. IF YOU DO NOT
PLAN TO USE SMALLER ROLLS,
YOU CAN SKIP THIS STEP.
ADD RIGHT SPINDLE WITH
SPRINGS AND TIGHTEN WITH
LOCKING NUTS.
SET SPINDLES AND SPINDLE
ROD SECTION IN HOLES ON
SUPPORT ARMS.

REVOLVER FILM LOADER ASSEMBLY AND INSTALATION
BOLT SPINDLE ROD TO
BOTH THE LEFT AND RIGHT
SUPPORT ARMS.
TO USE SMALLER ROLLS,
REMOVE THE APPRORIATE CORE
HOLDER AND ATTACH IT TO
THE DOG BONE ARM.
LOAD SMALLER ROLLS ON THE
MODIFIED HOLDER.

REVOLVER FILM LOADER ASSEMBLY AND INSTALATION
LOAD ROLLS ON THE REMAINING
ROLL HOLDERS.
07/21