Salamander EZ-Touch Manual Lift Wall Mounts - EZ1/MS50/ML095 501-765 [12.22] page 3 of 10
How to use this manual
1 Read manual carefully before you install the mount
2 Carry out the actions fully and in the given sequence
3 The mount guarantee is voided if the product is not correctly installed
ormodiedinanyway
Warning symbols used
A Sharp edges
B Wear glove
C Physical load
D Twopeoplerequired
E Entanglement hazard
F Warning: Can cause personal
injury or equipment damage
Intended use
The EZ-Touch Mount is a system that compensates the mass of vertically moving displays to
ease vertical movement of the display.
General warning
ThedisplaymayonlybeattachedtoorremovedfromtheEZ-Touchwhenthe
EZ-Touch is in closed position. The EZ-Touch is under strong spring force. Only operate
theEZ-Touchwithanadequatelybalanceddisplayattachedtothedisplayframe.
DonotremoveanypartsoftheEZ-Touch.Onlythenishingcovercanberemoved.
Mounting fasteners
Mountingfastenersarenotincludedwiththeproduct.Obtainadvicefromaspecialist.
Setting the springs
Adjust only the outer springs:
• Adjusttheheightoftheouterspringsequally
• Makesurethattheheightofthedisplayisbalanced
• Increasethespringtensionasmuchaspossible
• Makesurethatthedisplaydoesnotmoveup
Never adjust the inner springs
Disposal of the EZ-Touch
Springs should be unattached before disposal of the EZ-Touch. Sort the EZ-Touch,
the accessories and the packaging for the environmentally friendly recycling.
A
D E F
B C
Never adjust the inner springs!
