Salvo S401 User manual

S401 Quick Start Guide
V1.1

1
x 12
Note: 60mm x 60mm x15mm fans are
recommended. A single 60mm x 60mm x
25mm fan may be used on the bottom mounts,
but doing so will interfere with two 2.5” drive
mounts and one 3.5” drive mount.
60mm Fans (Optional)

x 4
Note: Be sure to install mainboard I/O shield
before installing mainboard.
2Mainboard

x 2
Note: Orientation of PSU is with FAN intake
face up.
3Power Supply Mounting Bracket

4Power Supply Extension Cable

x 2
5
Note: A foam anti-vibration pad has been
installed underneath the PSU retaining tab on
the chassis. Take care when installing the
PSU to ensure the foam pad is not damaged.
Before fastening the screws, please check for
any interference with the front panel button. If
you find the C14 connector makes contact with
the front button, you may choose to install the
front button spacer (black acrylic ring). Simply
remove the front panel button by unscrewing
the nut on the back, then insert the spacer on
the outside of the case and thread the button
wires back through both the spacer and the
mounting hole. Re-install the nut for the front
panel button. The spacer adds an additional
1/8” clearance.
Power Supply to Chassis

x 4
6a
Note: Up to four 2.5” drives can be installed.
Use holes labeled S-1, S-2, S-3, and S-4.
2.5” Drive Install

6a 2.5” drive mount locations

x 4
6b
Note: Two 3.5” drives may be installed. Use
holes labeled H-1 and H-2.
3.5” Drive Install

6b 3.5” drive mount locations

7a
Note: Angle GPU with I/O shield down and move
toward rear chassis slot.
GPU Install

7b
Note: Be sure to carefully align the PCIe tab
from the GPU to the PCIe extender and gently
insert.
GPU Install (Cont’d)

x 2
7c
Note: Tapped holes may strip if GPU screws are
over-tightened.
GPU Install (Cont’d)

x 4
8
Vented Panel Install

x 4
9
Solid Panel Install

10a
Note: Be sure orientation of the stand ensures
the key fastener aligns with the keyhole on the
chassis. Also, stands may be installed on either
end of the chassis depending on desired
orientation (vertically). If using horizontal
orientation, skip to step 11.
Stands

x 2
10b
Stands (Cont’d)

11a
If the passthrough holes for the thumbscrews
are not aligned the handle needs to be rotated
180 degrees.
Note: Like the stands, the handle may be
installed on either of two surfaces of the case. If
you are using the stands, the handle must be
installed on the opposite side of the case as the
stands.
Handle (Optional Accessory)

x 2
11b
Handle (Cont’d)