··1
..
>
If
the
remote
control
doesn't
work! Check the
following
1.
Is the TV power on?
2.
Are the plus
and
minus ends of the batteries reversed?
3.
Are the batteries drained?
4.
Is
there apower cut, or
is
the power cord unplugged?
5.
Is
there aspecial fluorescent light or aneon sign nearby?
Installing Batteries in the Remote Control
1
Lift
the cover at the back
of
the remote control upward
as
shown
in
the figure.
2Install two AAA size batteries.
> • Make sure
to
match the "+" and
"-"
ends
of
the batteries with the diagram inside the compartment.
•
Do
not mix battery types,
Le.
alkaline
and
manganese.
3Close the cover
as
shown
in
the figure.
>Remove the batteries and store them
in
acool and dry place if
you
won't
be
using the remote
control for along time. The remote control can be used
up
to
aDout
23
feet from the
TV.
(Assuming
typical TV usage, the batteries last for about one year.)
>Using the remote control with the On/Off(O) light button set
to
On
will reduce the battery usage
time.
•Connections
Connecting
VHF
and
UHF
Antennas
If
your
antenna has aset
of
leads
that
look
like this, see
"Antennas
with 300 nFlat Twin
Leads" below. (
If
your
antenna has one lead
that
looks
like this, see
"Antennas
with
75 nRound Leads".
If
you
have
two
antennas, see "Separate VHF and UHF Antennas".
--lmlJ=
Antennas with
300
0Flat Twin Leads
Plug the adaptor into the ANT
IN
terminal
on
the TV rear panel.
2
If
you
are
using
an off-air antenna (such as a
roof
antenna
or
"rabbit
ears")
that
has 300 n
twin
flat
leads,
follow
the
directions
below.
1Place the wires from the twin leads under the screws
on
a300-75 0adapter (not supplied).
Use ascrewdriver
to
tighten the screws.
Antennas with
75
0Round Leads
Plug the antenna lead into the ANT
IN
terminal
on
the TV rear panel.
ANT
IN
Separate VHF and
UHF
Antennas
If
you
have
two
separate antennas
for
your
TV (one VHF and one UHF),
you
must
combine the
two
antenna signals before
connecting
the antennas
to
the
TV.
This procedure requires an optional combiner-adaptor (available
at
most
electronics
shops).
1Connect both antenna leads to the combiner.
2Plug the combiner into the ANT
IN
terminal
on
the bottom of the rear panel.
