Samsung DM65D User manual

1
Target TV Programing Guide for DM65d/e Series
11/11/2015
Part 1 –How to Control One T.V. at a Time
1.1 Press the “SET” button on the remote.
1.2 Numbers will show on all the TV’s.
1.3 Press the corresponding number on the remote of the TV you need to control. Then press
return. (“0”->”1”-> “Return”)
1.4 The number on the TV will highlight and you will be changing settings on JUST that TV.
1.5 Check/change settings as needed, see Page 2 below for setting guide.
1.6 Press the “UNSET” button to get back out to controlling the whole wall.

2
1.7 Repeat Steps 1-6 for all T.V.’s that need settings changed.
Part 2 –Samsung DM65d/e TV Settings
2.1 Set Source Input. Note: Set Source Input type first as settings are stored and set by source input type
(DVI, DisplayPort, etc.)
Set the input on TV’s 1 & 5 to DVI.
Set the input on TV’s 2, 3, 4, 6, 7, 8 to Display Port.
Note: The following settings are accessed through the Home button on the remote.
2.2 Picture Mode Settings
Under Home -> Picture -> Picture Mode
Set Picture Mode to “Calibration”
2.3 ID Settings
Under Home -> ID Settings
Set the Following Items:
oSet Device ID to match the ID layout in Step 1.2. Note: Device ID is different than the
video wall screen position number shown below.
oSet PC Connection Cable to RS232C Cable
2.4 Video Wall Settings
Under Home -> Video Wall
Set the Following Items:
oApply to “Current Source”
oVideo Wall –On
oFormat - Natural
oHorizontal –2
oVertical –2
oScreen Position –Set Corresponding to Display Position

3
The following settings are accessed through the Menu button on the remote.
2.5 Auto Source Switching Settings
Under Menu -> System -> Auto Source Switching
Set the Following Items:
oAuto Source Switching –OFF
oPrimary Source Recovery –OFF
oPrimary Source –ALL
oSecondary Source –TV
2.6 Power Control Settings
Under Menu -> System -> Power Control
Set the Following Items:
oAuto Power On –ON
oMax. Power Saving –Off
oStandby Control –Off
oPower Button –Power On Only
oNetwork Standby –OFF
2.7 Eco Solution Settings
Under Menu -> System -> Eco Solution
Set the Following Items:
oEnergy Saving –Off
oEco Sensor –Off
oScreen Lamp Schedule –Off
oNo Signal Power Off –Off
oAuto Power Off –Off
2.8 General Settings
Under Menu -> System -> General
Set the Following Items:
oBD Wise –Off
oAnynet+ (HDMI-CEC) Off
oHDMI Hot Plug –On
oGame Mode –Off