Samsung VC-6313 User manual

Operating
Instructions
VACUUM CLEANER
❈ Before operating this unit, please read the instructions carefully.
DJ68-40144A 2001.11.29:15AM ˘`1

1
It has many desirable features, such as automatic cord rewind, dust indicator,
remote power control (Only remote control type) and others.
NOTE :Not all models have the same features.
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply in the name as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING:Do not use the vacuum cleaner when rug or floor is wet.
3. Close supervision is necessary when any appliance is used by or near children, do not
allow the vacuum cleaner to be used as a toy or to run unattended at any time. Use the
vacuum cleaner only for its intended use as described in the instructions.
4. Do not use the vacuum cleaner without a dust bag. Change the dust bag frequently
when picking up very fine materials such as powder. Change the dust bag before it is
excessively full in order to maintain best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep
the vacuum cleaner away from stoves or heat sources. Heat can deform and discolour
the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the
cleaner’s parts. Do not stand on the hose assembly or put a weight on the hose or
block the suction or the exhaustion part.
7. Switch the vacuum cleaner off at the machine before unplugging from the electrical
outlet. Grasp the plug to disconnect from power outlet to avoid damage to cord, plug,
prongs or socket. Always disconnect cord from electrical outlet before changing the
dust bag or servicing the cleaner.
8. The use of an extension cord is not recommended.
9. If your vacuum cleaner is not operating correctly, switch off the power supply and
consult an authorized service agent.
10. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
1. This hose contains electrical connections (only remote control type)
2. Do not use to suck up water.
3. Do not immerse in water for cleaning.
4. The hose should be checked regularly and must not be used if damaged.
FEATURES
IMPORTANT SAFEGUARDS
Warning
NOTE :
DJ68-40144A 2001.11.29:15AM ˘`2

2
IDENTIFICATIONS PARTS
REMOTE POWER CONTROL
(Only remote control type)
SUCTION REGULATOR
* TUBE
HOSE
DUST INDICATOR
CARRING
HANDLE
DUST COVER
HOSE CLAMP
*FLOOR NOZZLE
Features maked * may vary according to model.
▼
RUG/FLOOR
SELECTOR
BUTTON CORD REWIND
ON/OFF
SWITCH
* BELT-STRAP ASSY
* HANGER ACCESSORY * BRUSH-DUSTING
CREVICE-TOOL
DJ68-40144A 2001.11.29:15AM ˘`3

3
ASSEMBLING THE VACUUM-CLEANER READY FOR USE
RUG/FLOOR SELECTOR
1. Slide the free end of the extension wand into the nozzle tube.
2. Slide the narrow end of one extension wand into the other
extension wand.
3. Slide the extension wand into the handle end of the hose.
4. Slide the hose clamp into the suction inlet of the unit.
* Option Ajusting the telescopic tubes (depending on
model)
Push the side ①when cleaning the capets.
Push the side ➁when cleaning the floor, tile, mat, etc.
After cleaning with floor brush keep it clean by using
crevice tool in order to maintain best cleaninng efficiency.
①
①
➁
➁
➂➃
FOR UNIVERSAL BRUSH
Use the floor nozzle for cleaning smooth
flooring,tiles,mats,carpet,etc.
NOTE :
Before use make sure that the position of the select button is in the right position
for the type of surface to be cleaned.
*OPTION
EXTENDING : Holding narrow
side of the telescopic tube with a
hand, pull the handle to the
oppo-site side of it with another
hand.
SHORTENING : Push the
handle
to the narrow side
of the tube, hoding
it with another
hand.
DJ68-40144A 2001.11.29:15AM ˘`4

4
SUCTION POWER CONTROL (ONLY REMOTE CONTROL TYPE)
Your cleaner has a variable electronic suction control to give you greater versatility.
Select the most suitable position according to cleaning needs.
HANDLE AND OPERATING CONTROLS (ONLY REMOTE CONTROL TYPE)
The suction capacity can be regulated steplessly by moving the slide to the desired
position SLIDE IN THE STOP POSITION(A)
Vacuum cleaner switches off (stand by mode)
SLIDE TOWARDS MAX(A)
Suction capacity increases steplessly up to MAX.
DUST INDICATOR
You may continue cleaning until the dust indicator changes into the red color. This
means the dust bag is full and needs to be replaced.
If the indicator suddenly works and the cleaner loses suction power while in use, turn
your cleaner off and check whether the hose, pipe or nozzle is clogged.
When you check bag status by indicator, set motor power on maximum position.
NOTE : Hose must be disconnected
NOTE : before changing bag.
NOTE : Replace the dust bag as soon
NOTE : as it is full.
1. To open the dust cover of the dust bag
compartment, lift the cover upward.
2. Remove the dust bag from the cleaner.
3. Dispose of the full bag and insert the
cardboard bag collar of the dust bag as
far as it can go on the suction inlet, and
press down the locker,position the dust
bag so that no part of the bag is pinched.
4. Press the front of dust cover down lightly
until it re-locks.
A
LOCKER
NOTE :
DUST REMOVAL(DUST COVER)
DJ68-40144A 2001.11.29:15AM ˘`5

5
STANDS ON END
Your cleaner is designed to stand firmly upr-
ight for cleaning or storage.Use in this man-
ner and it takes up a minimum of space,
and allows you to work in the narrowest
spaces.
CORD STORAGE
To extend the power cord for use, grasp the
plug and gently pull out from the vacuum cl-
eaner.When removing the power cord from
the electrical outlet,switch off the power and
grasp the plug.
Your cleaner is equipped with an automatic
rewind button.When cleaning is finished,
switch off power and disconnect the plug fr-
om the electrical outlet then press on the
cord rewind button with your hand.
The cord will be rewound automatically.
PAPER DUST BAG
After using,if the paper dust bag is full, dispose of it. Do not reuse.
CLOTH FILTER BAG
After using,if the cloth filter bag is full of dust, clean the cloth filter bag and use it again.
NOTE:There are two types of dust bag according to the model,one is paper dust bag
type the other is cloth filter bag type.
Press
NOTE :
DJ68-40144A 2001.11.29:15AM ˘`6

6
Your cleaner features an inside tool storage
space.
It can be used to store cleaning tool while
they are not in use.
Dusting brush for funiture, shelves, books,
etc.
Crevice tool for radiators, crevice, corners,
between cushions.
This appliance is designed to be carried
and available on the waist for your convenience.
When cleaning steps, curtains, shelves, etc,
carring the unit with the strap on your shoulder.
TOOL STORAGE
USING & ASSEMBLING THE STRAP
Slide the lockers into its counterparts
on the carring handle,taking care of
locking directions.
▼▼
DJ68-40144A 2001.11.29:15AM ˘`7

7
IF YOU HAVE A PROBLEM
This appliance was inspected thoroughly and was in good operating
condition when it was shipped from the factory.
If a minor problem occurs,it usually can be solved quite easily when the cause is found.
Therefore,this check list is provided for your convenience.
DJ68-40144A REV(0.4)
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner Won’t Run 1.Not firmly plugged in. 1.Plug in firmly.
2.No voltage in wall plug. 2.Check fuse or breaker.
Cleaner Doesn’t 1.Dust bag is full. 1.Change dust bag.
Pick Up Properly 2.Hose clogged with 2.Romove substance.
a large object.
DJ68-40144A 2001.11.29:15AM ˘`8