S&S Precision PF-R PlateFrame Redux User manual

PF-R™ PlateFrame Redux
END USER INSTRUCTIONS - READ BEFORE USE
PRODUCT NAME:
PART NUMBER:
PFR-000
PAGE 1 OF 4 ©2021 S&S Precision, LLC | 05062021
1Remove from box and separate the front of the PF-R from the back by
disconnecting the shoulder strap Velcro. (The back of the PF-R has the drag
handle and cummerbunds)
2Lay the front PF-R face down and lay out completely open.
3Insert Armor Plate under elastic
band from the bottom and line
bottom of Armor Plate with
bottom of Tegris stiener frame.
4Fold shoulder strap flap up and
secure corners with velcro straps.
FRONT BACK

PF-R™ PlateFrame Redux
END USER INSTRUCTIONS - READ BEFORE USE
PRODUCT NAME:
PART NUMBER:
PFR-000
PAGE 2 OF 4 ©2021 S&S Precision, LLC | 05062021
5Close by folding top flap
down. Ensure shoulder straps
are centered up. Readjust if
necessary.
6Lay the back PF-R face down and
lay out completely open.
7Insert Armor Plate under elastic
band from the bottom and line
bottom of Armor Plate with top of
the trapezoid shaped cutout
in PF-R.
8Fold shoulder strap flap up and
secure corners with velcro straps.

PF-R™ PlateFrame Redux
END USER INSTRUCTIONS - READ BEFORE USE
PRODUCT NAME:
PART NUMBER:
PFR-000
PAGE 3 OF 4 ©2021 S&S Precision, LLC | 05062021
9Close Top by passing top flap
under drag handle and folding
down. Ensure shoulder straps
are centered up. Readjust if
necessary.
10 Slide shoulder strap sleeves onto
the shoulder straps connected to
the back of the PF-R. Bunch them
up tight to the drag handle.
11 Reconnect the front of the PF-R to
the back with the shoulder strap
Velcro.
12 Slide shoulder strap sleeves back
onto the connected PF-R shoulder
straps.

PF-R™ PlateFrame Redux
END USER INSTRUCTIONS - READ BEFORE USE
PRODUCT NAME:
PART NUMBER:
PFR-000
PAGE 4 OF 4 ©2021 S&S Precision, LLC | 05062021
2
1Unvelcro Autofit Cummerbund
sleave
To clean, hand wash with mild detergent and rinse with fresh water. Let air dry out
of the sun. Store in a cool and dry environment.
Check cummerbund attachment point hardware. If hardware is loose, ensure to
use thread locker and hand tighten. Always reapply thread locker if changing out
cummerbunds or replacing hardware.
OPEN CAMERA TO
VIEW USER INSTRUCTIONS OR VISIT
WWW.SSPGEAR.COM/
END-USER-INSTRUCTIONS
AUTOFIT CUMMERBUND ADJUSTMENT CARE AND MAINTENANCE
Tighten or loosen Autofit
Cummerbund flat friction lock and
bungie cord do get the desired
fitment.