Bluewater 100425 User manual

SKYLIGHT DEMARCATION KIT
ASSEMBLY INSTRUCTIONS
4064 Peavey Rd. Chaska, MN 55318
BY:
Paul Boyum
DATE:
11/06/2015
REVISION:
Toll Free: 866-933-2935
P/N:
100425
A
www.bluewater-mfg.com
Page 1of 3
THE INFORMATION CONTAINED IN THIS DOCUMENT IS THE SOLE PROPERTY OF BLUEWATER MFG., INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF BLUEWATER MFG., INC. IS PROHIBITED.
RECOMMENDED TOOLS FOR ASSEMBLY:
CORDLESS DRILL
SOCKET SET
PLEASE NOTE: Skylight demarcation markers must be used in addition to an OSHA approved skylight
guard. The markers do not meet OSHA fall protection requirements when used alone.

SKYLIGHT DEMARCATION KIT
ASSEMBLY INSTRUCTIONS
4064 Peavey Rd. Chaska, MN 55318
BY:
Paul Boyum
DATE:
11/06/2015
REVISION:
Toll Free: 866-933-2935
P/N:
100425
A
www.bluewater-mfg.com
Page 2of 3
THE INFORMATION CONTAINED IN THIS DOCUMENT IS THE SOLE PROPERTY OF BLUEWATER MFG., INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF BLUEWATER MFG., INC. IS PROHIBITED.
1. Place the carriage bolts through the angle marker mount.
2. Place the retaining clip onto the carriage bolts.
3. Screw nylock nuts onto carriage bolts.
4. Place the fiberglass stake between the angle marker mount and the retaining clip.
a. Ensure that the bottom of the stake is resting on the angle marker mount.
5. Tighten the nylock nuts onto the carriage bolts until snug.
a. Ensure that the stake does not pull free from the mount housing.
6. If fastening the Skylight Demarcation Kit to a Bluewater Mfg. Skylight Defender continue,
otherwise proceed to page 3 of 3.
7. Remove the nylock nut and the washer from the threaded rod located on the Skylight Defender.
8. Insert the assembled Skylight Demarcation Kit onto the threaded rod.
9. Place the washer onto the threaded rod.
10. Place the nylock nut onto the threaded rod and re-tighten nut to the Skylight Defender frame.

SKYLIGHT DEMARCATION KIT
ASSEMBLY INSTRUCTIONS
4064 Peavey Rd. Chaska, MN 55318
BY:
Paul Boyum
DATE:
11/06/2015
REVISION:
Toll Free: 866-933-2935
P/N:
100425
A
www.bluewater-mfg.com
Page 3of 3
THE INFORMATION CONTAINED IN THIS DOCUMENT IS THE SOLE PROPERTY OF BLUEWATER MFG., INC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN
PERMISSION OF BLUEWATER MFG., INC. IS PROHIBITED.
11. Please note: the Skylight Demarcation Kit may be installed and placed anywhere along the side
of any skylight guard.
12. Place the Skylight Demarcation Kit along the side of the skylight guard.
13. Fasten the Demarcation kit securely to the skylight frame by using self-drilling screws with a
rubber washer, not provided by Bluewater Mfg.
a. The recommended self-drilling screw size to use is 12-24 x 7/8” for most applications.
14. If penetrating the interior of the skylight, sealant must be applied between the demarcation
marker mount and the skylight frame.