Sandstrom S15PBS10 User manual

Instruction Manual
Stainless Steel Blender
S15PBS10
GB-4 GB-5
Visit Partmaster.co.uk today for the easiest
way to buy electrical spares and accessories.
With over 1 million spares and accessories
available we can deliver direct to your door
the very next day. Visit www.partmaster.co.uk or call 0870 6001 338 (UK
customers only) Calls charged at National Rate.
This symbol on the product or in the instructions means that your
electrical and electronic equipment should be disposed at the end
of its life separately from your household waste. There are separate
collection systems for recycling in the EU. For more information,
please contact the local authority or your retailer where you
purchased the product.
SPECIFICATIONS
Power : 230V~50Hz, 750W
Capacity of Jug : 1.5 L
Duty Cycle : 3 minutes ON; 1 minute OFF
We continually strive to improve our products, specifications may change without
prior notice.
SAFETY FIRST!
For your continued safety and to reduce the risk of injury or electric shock,
please follow all the safety precautions listed below.
• Read all the instructions carefully before using this appliance and keep them
for future reference.
• Unplug the appliance from the mains supply when not in use, when removing
or attaching the blender jug, or before cleaning any part of the appliance.
• This appliance is for household use only. Do not use it for professional
catering.
• Do not use the appliance outdoors.
• Do not immerse the appliance base unit or the mains cable or plug in liquids.
• Do not use the appliance near a source of heat or on an unstable surface.
• Do not use your appliance in damp or wet conditions.
• Never let children operate this appliance. Close supervision is necessary when
this appliance is used near children.
• This appliance is not intended for use by persons (including children) with
reduced physical sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction concerning
the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• Ensure that the mains cable does not touch any hot surface and that it does
not overhang the edge of your work surface.
• There are no user serviceable parts in your appliance.
• Do not operate the appliance with a damaged mains cable or mains plug or
after the appliance or any attachment has been damaged. Seek qualified
technicians for assistance.
• If the mains cable is damaged it must be replaced by the manufacturer, its
service agent, or similarly qualified persons in order to avoid a hazard.
• Do not use attachments or accessories which are not recommended by the
manufacturer. They may cause malfunction or injury.
• Store the appliance away from direct sunlight and out of the reach of children.
When operating your blender:
• Do not place your hand in the blender jug. The sharp blade may cause injury.
• Never insert any hard object or implement into the blender jug when it is
operating. This may cause damage to the appliance and personal injury.
• Do not place meat containing bones or fruits with large hard stones in the
blender jug.
• If the blender becomes clogged, switch off and unplug the mains cable from
the mains socket before cleaning the obstruction. Check carefully for damage.
• Do not use the appliance for any purpose not expressly specified in this
manual.
• Switch off the appliance before charging accessories or approaching parts
which move in use.
DGS Retail Ltd • Maylands Avenue • Hemel Hempstead •
Herts • HP2 7TG • England
Congratulations on the purchase of your new
Sandstrøm Blender.
We recommend that you spend some time reading this instruction manual in
order to fully understand all the operational features it offers.
Read all the safety instructions carefully before use and keep this instruction
manual for future reference.
STORAGE
After all the components have been washed and dried, re-assemble the blender
and store it out of direct sunlight and out of the reach of children.
The mains cable may be wound around the lugs at the bottom of the appliance
for easier storage.
CLEANING
Cleaning the blender jug:
1. Pour about 500ml of warm soapy water into the jug and place the jug on the
base.
2. Use Speed ‘1’ for a few seconds to loosen any food particles and free them
from the blades.
• Remove the jug, pour away the water and rinse in fresh running water.
Repeat steps 1 and 2 with fresh water.
• Alternatively the jug may be immersed in warm soapy water and cleaned
using a long handled brush. Do not touch the blades when cleaning.
• Wash the lid and measuring cup separately in warm soapy water, rinse and
allow to dry.
• CAUTION: The jug body should be handled carefully. The jug contains moving
parts - do not leave the jug immersed in water for longer than necessary to
clean it or you may affect the operating performance of the blender.
• DO NOT wash the jug or attachments in a dishwasher.
Cleaning the base:
• Ensure the blender is switched off and unplugged from the mains.
• Wipe the outer surface of the motor unit with a damp cloth. Never use abrasive
cleaners or scouring creams.
Never immerse the base in water when cleaning.

GB-1 GB-2 GB-3
UNPACKING
Remove all packaging from the blender. Retain the packaging. If you dispose of it
please do so according to local regulations.
The following items are included:
• The Main Unit
• The Blender Jug (P.N.: 502217971)
• The Blender Jug Cover (P.N.: 002369263)
• The Measuring Cup (P.N.: 002241103)
• Instruction Manual (P.N.: 553154132)
If items are missing, or damaged please contact Partmaster (UK only).
Tel: [phone] for assistance.
FIRST TIME USE
• Before using your blender for the first time, wash the jug, blade assembly, lid
and measuring cup. Rinse throughly and dry.
• Place the base unit on a stable surface, free from heat and moisture and within
easy reach of a mains socket. The mains cable should not be taut.
PREPARING AND FILLING THE INGREDIENTS
• Cut the ingredients into 25mm (1”) cubes before placing them into the blender
jug. If the food is very hard or dry, cut the pieces into smaller cubes.
• Fill the blender jug with the ingredients.
• Do not overfill the jug. The maximum capacity is 1500 ml, but we suggest you
do not exceed 1250 ml. If you are preparing a large quantity use several
smaller batches.
• If the ingredients are too dry, put some liquid into the jug. You should never try
to reduce dry ingredients in the blender.
PRODUCT OVERVIEW
OPERATION (Cont)
During blending, you can feed in small amounts of food or liquid through the jug
lid. To do this:
Stop the blender and hold the lid.
Turn the measuring cup slowly anti-clockwise to free it and then lift it out.
Gradually feed pieces of food or liquids into the jug through the feeder.
Fit the measuring cup back when you have finished.
FITTING THE LID
• Place the lid on the top of the jug and turn the lid clockwise. Make sure that the
lid is properly secured.
• Do not run the appliance continuously for more than 3 minutes. After 3
minutes the appliance will auto - stop. Allow the blender to rest for 1 minute
before using it again.
• Never blend very hot liquids in the blender. This is dangerous as the
pressure inside the jug will build up and may cause the contents to escape
from the jug.
• If you spill liquid on the blender base immediately switch off and wipe dry.
• Do not run the appliance without securing the lid and measuring cup.
mL
1500 1
1/2
L
1250 1
1/4
1000 1
750 3/4
500 1/2
250 1/4
1 2
Pulse Off Ice
3 4 5
1 2
Pulse Off Ice
3 4 5
mL
1500 11/2
L
1250 11/4
1000 1
750 3/4
500 1/2
250 1/4
1 2
Pulse Off Ice
3 4 5
FITTING THE MEASURING CUP
The measuring cup has an integral measuring cup which is useful for measuring
small amounts of ingredients.
• Place the measuring cup in the slots on the lid and turn clockwise to lock. Make
sure the measuring cup is properly secured. To avoid splashing, always operate
the blender with the measuring cup firmly in place.
OPERATION
1. Make sure the jug and the lid are secure and in the LOCK position.
2. Plug your blender into the mains and switch on the power.
3. The timer will display 0:00 and the Off button will illuminate.
4. Open the lid and put food into the jug. Close the lid and slightly push the lid to
release the air pressure from the jug.
FITTING THE JUG TO THE BASE UNIT
• Place the blender jug on the base unit as shown.
The jug will fit in 4 positions : handle facing, front,
left side, right side, rear. If the jug is not properly
fitted to the base the blender will not start.
1 2
Pulse Off Ice
3 4 5
mL
1500 1
1/2
L
1250 1
1/4
1000 1
750 3/4
500 1/2
250 1/4
The lid must be secured to the jug and the
jug to the base otherwise the blender will not
operate!
Blender's Operation Modes
• To turn on the blender in continuous mode, press one of the
following Speed buttons: 1 (slowest), 2, 3, 4 or 5 (fastest).
The button for the speed you select will illuminate blue and
the blender’s timer will display the seconds.
• The blender will run continuously after you press the Speed
button. It will stop if you press the same Speed button
again. The timer will also stop. To continue simply press the
same Speed button again. When the timer reaches 3
minutes, the unit will automatically shut off.
• You can change blender speeds by pressing a different
Speed button without pressing the Off button. The timer
feature will continue while you are blending and will pause
in its count when you re-push a Speed button to shut the
blender off. The timer will re-set itself to zero only if you
press the Off button.
• To run the blender intermittently (pulse mode) rather than
continuously, first press the Pulse button. The Pulse
button light will flash blue. Then press and hold one of the
five Speed buttons above it to run the blender at that
speed. The Speed button you press will illuminate blue.
When you release the button the blender will stop and turn
Off.
• The Pulse operation time can accumulate up to 3 minutes.
Continuous
(Normal)
operation
Pulsed
operation
• The Ice Crush button is the highest and strongest blender
speed. When crushing ice, make sure that the lid is firmly
closed.
• The blender will begin to operate at this speed as soon as
you press the Ice Crush button, but will only continue to
operate as long as you hold the Ice Crush button down (up
to 3 mins). Press the Ice Crush button in quick succession
but do not hold the button down. While the Ice Crush
button is pressed, it illuminates blue. As soon as you stop
pressing the button, the blender turns Off.
• Put some ice cubes into the jug (12 to 15 ice cubes). There is
no need to add water. When the ice is ready, stop the
blender. Use spoon to pour out the crushed ice.
Ice Crushing
AFTER USE
After you have finished blending:
• Press the off button.
• Hold the jug by the handle and carefully raise to release the jug. (This may be
easier with one hand on the base and one hand holding the jug handle).
• Lift off the lid and pour or spoon out the contents carefully.
• Unplug the blender from the mains socket.
Safety Lid
Blender Jug
Measuring Cup
Handle
Measuring
Scale
Blade Assembly
Speed buttons
Timer
Pulse
Button
Off
Button
Ice Crush
Button
Base Unit