Sanitaire HydroClean SC930A User manual

Compared to traditional hard oor cleaning methods for commercial
buildings, the Sanitaire®HydroClean™eliminates steps to double your
productivity* and help you get more done in less time.
Times Savings For Commercial Buildings
Vacuum +Wash All At Once Cut Cleaning Time In Half* Drop The Mop Self-Cleaning Function
TRADITIONAL CLEANING METHODS
VACUUM +WASH
ALL AT ONCE
ONE STEP:
VACUUM
OR
ANGLE BROOM
OR
LINT / STICKY ROLLER
STEP 1:
SPRAY BOTTLE
&
MICROFIBER MOP
OR
MOP & BUCKET
STEPS 2 & 3:
*Based on an AICS Time & Motion Study as compared to a typical three-step manual cleaning process.
VS.
SANITAIRE®HydroClean™
HydroCleanTM
Hard Floor Washer
MFG # SC930A
© 2022 BISSELL Inc.

HydroCleanTM - SC930A - Quick Reference Guide
Fill the solution tank and
insert into machine. Turn the machine on
pressing the power button.
Fill solution tank with warm
(140°F/60°C MAX) tap water and
add the recommended formula.
1
click!
3
2
654
10 seconds
To turn off, press the
button a second time.
Recline the body of the oor washer
backward to start the brush roll spinning.
Before each use, hold the solution
spray trigger for 10 seconds to
prime the system with cleaning
solution. LED lights will illuminate
when holding the trigger.
NOTE: When solution is owing you
will see bubbles forming at the
edges of the brush roll window.
To clean, hold the solution spray
trigger to apply solution on both
forward and backward passes.
TIP:
To dry hard oors
faster, release the
trigger and clean a
second pass without
dispensing solution.
TIP:
TIP:
For lighter spills, hold the trigger down
on the forward pass and release when
pulling back to reduce drying time.
TIP:
For overly challenging and stuck-on
messes on your hard oors, hold the
Sanitaire®Hard Floor Washer over the
mess. Using short passes while holding
the trigger allows the multi-surface
brush to go to work.
7
60 seconds
After use, place the handle in upright
position, turn off the power and depress
the self-clean button.
The indicator light will blink for 60 seconds
while clean solution is dispensed on the
brush roll and vacuumed back into the
dirty water tank.
Floor washer will shut off when cycle is
complete. Repeat as necessary.
Self-Cleaning Function:
8
Empty and clean dirty water tank
when nished.
Rinse the oat located at the bottom of the
dirty water tank lid.
After daily use, hand wash the lter and
screen with warm water and detergent.
NOTE: Store floor washer in a protected, dry area. Since this product uses water, it
must not be stored where there is a danger of freezing. FREEZING WILL DAMAGE
INTERNAL COMPONENTS AND VOID THE WARRANTY.
9
Allow parts to
completely dry.
Scan QR Code to View
Maintenance Video
© 2022 BISSELL Inc.