Sanlien Palert User guide

P-alert Earthquake
P-wave Detector
Hardware System Installation Instruction
•Version 1.01 2015/03.18
•Automation Division, San Lien Technology Crop.
•3F, No.190, Sec. 2, Zhongxing Rd., Xindian Dist.,
New Taipei City, 23146 Taiwan.
•TEL:[phone] FAX:[phone]

Install PALERT Hardware
Basic Environment Required:
1. Power: 110 v indoor power
2. Ethernet : RJ45 port with IP address attached
3. Sturdy Building (ex: Wall, Beam, column)
Installation Items Required:
1. PALERT
2. DC24V Adaptor
3. RJ45 Ethernet Cable
(There jumper cable network can connect PC
with PALERT directly, or you must go through HUB)
4. Cross-Head and SHCS Screw Driver, Automation
Screw Driver
5. Wall Frame and PALERT Back Board.
6. SHCS screws, Common Screws and
Plastic(or metal) Anchor Screws, M4 screws.
7.Hammer, Bubble level meter, Pen.
(tools Photo see as next 3 pages)

Installation steps:
1. Find the north direction of the installed room.
the PALERT b-axis will be aligned that direction.
A
B
NS
UD
EW
C

2. Select the wall (column) that PALERT wants to
fixed on it.
To determine the true seismic wave, suggest the
wall installed should be concrete or SRC
material.
Sturdy wall can makes seismic wave
performance better!!

3. Using bubble level meter measure the leveling of
PALERT frame fixed place.

4. Marking 4 dots with pen through frame hole and
drill the 4 holes at that dots by automation screw
driver.

5. Hit plastic (metal) anchor screws into the drilled
hole, than locked the PALERT frame on the wall
with common screw. (see as next page)
or

Outsides the wall:
Insides the wall :
The sequence form inner
to outer wall are plastic
anchor screw, wall,
common screw.

5. Screwing the SHCS screw between the back board
and the frame.
Frame
Back Board

5. Locking the PALERT on the back board with the
M4 screws.

6. Connect the power and Ethernet cable and then
finished the PALERT hardware installation.