Sanus CFR518 User manual

Sanus Systems
2221 Hwy 36 West
Saint Paul, MN 55113 USA
Customer Service
Americas: 800-359-5520 • 651-484-7988 • [email protected]
Europe, Middle East, and Africa: 31 (0) 40 26 68 619 • [email protected]om
Asia Pacific: 86 755 8996 9226 • 800 999 6688 (mainland China only) • [e-mail]
sanus.com
©2009 Milestone AV Technologies, a Duchossois Group Company.
All rights reserved. Sanus is a division of Milestone.
All other brand names or marks are used for identification purposes and are trademarks of their respective owners.
CFR518, CFR524, & CFR535
(6901-002027 <00>)

6901-002027 <00>
2
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS - PLEASE READ ENTIRE MANUAL BEFORE USING THIS PRODUCT
Thank you for choosing a Sanus Foundations Component Series Rack. The CFR518, CFR524, and CFR535 are designed to support audio/video equipment.
ÙThe total weight capacity for the CFR518 is 453.6 kg (1,000 lbs).
ÙThe total weight capacity for the CFR524 is 453.6 kg (1,000 lbs).
ÙThe total weight capacity for the CFR535 is 453.6 kg (1,000 lbs).
CAUTION:
CAUTION: Avoid potential personal injuries and property damage!
ÙDo not use this product for any purpose not explicitly specied by Sanus Systems.
ÙIf you do not understand these instructions, or have doubts about the safety of the installation, assembly or use of this product, contact Sanus Systems
Customer Service or call a qualied contractor.
ÙSanus Systems is not responsible for damage or injury caused by incorrect assembly or use.
WARNING:
WARNING: Avoid potential personal injuries and property damage!
ÙDo not exceed the stated weight capacities.
ÙDo not shake, tilt, rock, sit, stand, or climb on your Component Series Rack. Tipping may cause injury or death.
ÙDo not move large racks by yourself; due to weight and height, assistance is required.

6901-002027 <00> 3
?
?

Choose an Option Do Not Loosen/Tighten Note This End Up.
LEGEND
WARNING This product
contains small items that
could be a choking hazard
Tools Required Caution/Warning Repeat Step Heavy! Assistance Required.
OPT
OPT
Electrical Warning Troubleshooting and
Maintenance Tip Hazard Optional

6901-002027 <00>
4
Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; contact Sanus
Systems Customer Service. Never use damaged parts!
Supplied Parts and Hardware
[02] x 4
[03] x 4
[04] x 16 [05] x 16 [06] x 16
[01] x 1

6901-002027 <00> 5
CAUTION:
Install feet [02] (recommended) and adjust them as neccessary to level the rack – OR – install castors [03].
DO NOT install both feet [02] and castors [03].
CAUTION: To avoid potential injury or property damage, always ensure that your rack is level.
Step 1
4x
4x
[02]
[03]
[05]
[04]
[06]
?
?

6901-002027 <00>
6
Numerous knockouts (K) are provided for cable management. You can route your cables through the knockouts or through the opening (O) in the bottom
panel.
CAUTION: All knockouts that are used for wires without conduit must have bushings inserted in the knockout to eliminate damage to the cable's insulation.
Step 2
OPT
OPT
CAUTION:
(K)
(K)
(K)
(O)

6901-002027 <00> 7
Remove the venting panel for additional ventalation.
CAUTION: To avoid damage to your components due to overheating, ensure that there is adequate space between each unit for proper airow. It is
important to maintain an operating temperature inside of the rack that does not exceed 104°F (40°C).
Step 3
OPT
OPT
CAUTION:

6901-002027 <00>
8
Adjust the rails within one slot – OR – adjust the rails into any of the slots provided.
NOTE: Be sure to adjust the top (T), bottom (B), right (R), and left (L) rails evenly.
Step 4
OPT
OPT
4x
(T)
(B)
4x
?
?
(T)
(B)
(R)
(L)
(R)
(L)

6901-002027 <00> 9
Verify that your grounding wire (W) is installed to the bottom rail hole (H) and the base ground stud (S) on the rack.
CAUTION: Avoid potential injury or property damage! The grounding wire must be properly installed at all times.
Step 5
CAUTION:
(S)
(H)
(W)

6901-002027 <00>
10
Milestone AV Technologies and its aliated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation
or use of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty,
expressed or implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or suciency of the information contained in this
document.