Sapa REDD Team Dura-Grip OSHA User manual

Dura
Dura- -Grip
Grip OSHA OSHA
System Assembly
System Assembly
OSHA Compliance
Dura-Grip
Modular Building Access

OSHA
OSHA
Platform Components
Platform Components
Short
Guardrail
Legs
Hardware
Bag
Long
Guardrail
Platform
Cone
Platform
Leg Pads

OSHA
OSHA
Stair Components
Stair Components
Stair Riser Stair Rail
Stair
Cone

OSHA
OSHA
Step Assembly
Step Assembly
1. Insert legs into
platform cones,
with leg pads
facing inwards
2. Using 5/16”x 2 ½”
bolt, finger tighten
at following
heights:
25 ½” - 2 step system
34” - 3 step system

OSHA
OSHA
Step Assembly
Step Assembly
3. Flip upright and
attach stair riser
using (2) 5/16” x
4 ½” long screws,
washers and hex
nuts, 1 each side

OSHA
OSHA
Step Assembly
Step Assembly
4. Bring system
flush to
building so
platform is
level with
threshold

OSHA
OSHA
Step Assembly
Step Assembly
5. Lag platform to
building with (3)
¼” x 3” lag
screws
6. Adjust each leg
as elevation
dictates

OSHA
OSHA
Step Assembly
Step Assembly
7. Insert short
guardrail into
platform cone so
that it rests on 4
½” long bolts
8. Attach rail to
building with
5/16” x 3 ¾” lag
screws

OSHA
OSHA
Step Assembly
Step Assembly
9. Insert long
guardrail into
platform cone and
attach to short
guardrail with
5/16” x 3 ¾” bolt
provided

OSHA
OSHA
Step Assembly
Step Assembly
10. Install the stair
rail by inserting
the bottom rail
into platform cone
then top, make
sure stair rail
rests on the 4 ½”
long bolts

OSHA
OSHA
Step Assembly
Step Assembly
11. Attach stair rail
to long
guardrail with
5/16”x 3 ¾”
long bolt
provided

OSHA
OSHA
Step Assembly
Step Assembly
12. Make sure
ground is level
at bottom of
first riser -add
or remove dirt
as necessary,
must maintain
8 ½” rise to
remain code
compliant

OSHA
OSHA
Step Assembly
Step Assembly