ADVANCED SIMRACING ASR6 User manual
A D V A N C E D
S I M R A C I N G
ASR6
ASSEMBLY
GUIDE
Tools
- measuring tape
- allen key 3/16 All the pieces
2x50"
1x 19"
Per corner
- 2 corner gusset
- 4 tnutz and 4 screws
Put screws and t-nutz in
corner gusset.
leave enough space to
slide in aluminum
Do not tighten gusset.
slide the 19" bar
Slide the "T" into the slot
Once everything is
aligned , tighten all
screws.
Put the screws
and t-nutz in the
plates and slide
them to the
desired position.
Insert the rubber
feet and put the nut
to maintain the feet
in position
Prepare all 4 legs
and plates.
Once all for corners
are done, flip it over.
Time for the
side posts
insert t-nutz in
the aluminum
first
Screw the
thick plate
onto the post
Insert the t-nutz
in the first and
last slot
Screw the post
onto the base at
around 16"
Here you go!
2 x 22" seat
posts
Don't tighten
these right away
Time for the
shifter arm
Screw the post
onto the base Screw the upper
aluminum bar
Once to the
desired position,
tighen
everything
Now you can
put the plastic
end caps...OR...
wait till the end
as it's a bit
more satisfying
Time to install
the wheel deck
Slide in the
wheel deck
For the DD
base, install the
add-on to your
fanatec first
then slide in
the side posts.
