Saxby Laryn PIR Manual

• Thissystemcontainsnon-replaceablepartsandcannotbeserviced.Ifdamageoccursthepartshould
bescrapped.
Instructionleaflet
Laryn PIR
www.saxbylighting.com
Foryoursafety,alwaysswitchoffthesupplybeforecleaning.
Wasteelectricalproductsshouldnotbedisposedofwithhouseholdwaste.Pleaserecyclewherefacilities
exist.CheckwithyourLocalAuthorityorretailerforrecyclingadvice.
Recycling advice
Safety information
SaxbyLightingLtd.BH233PE
Werecommendcleaningwithasoftdrycloth.
Donotusesolventsorabrasivecleanersasthesecoulddamagethefinish.
Fitting/replacing bulbs
Iss.423022016
54408,54409,68805,68806

Thankyouforpurchasingthislightfitting.Pleasereadtheinstructionscarefullybeforeusetoensuresafeand
satisfactoryoperationofthisproduct.Pleaseretaintheseinstructionsforfuturereference.
Warning
Thisunitcannotbedimmed.
Thisproductcontainsnon-replaceablepartsand
cannotbeserviced.Ifdamageoccurstheproduct
shouldbescrapped.
Wasteelectricalproductsshouldnotbedisposedof
withhouseholdwaste.Pleaserecyclewherefacilities
exist.Checkwithyourlocalauthorityorretailerfor
recyclingadvice.
ThisproductisratedatIP44.
Thisproductisnotsuitableforlocationinorneara
marineenvironment.
Battery Care:-
- Donotrechargenon-rechargeablebatteries.
-Donotmixoldandnewbatteriesorbatteriesof
differenttypes/brands.
-Donotuserechargeablebatteries.Alwaysremove
exhaustedbatteriesfromtheproduct.
-Alwaysinsertbatterieswiththecorrectpolarity.
-Donotshortthesupplyterminals.
-Thisproductissuitableforusebyadultsonly.
Specification
Voltage: 4.5V
Lamp: 54408:1x2WLEDmodule(SMD5630),54409:2x2WLEDmodule(SMD5630)
IPrating: 44
BatteryType: 3x1.5VLR14‘C’(notsupplied).Usinggoodqualitybatteries,theexpectedlengthoftime54408/
 68805willoperateis9hours,and4.5hoursfor54409/68806.
Layout
• Avoidmountingonsurfacessubjecttovibration,as
thismayaffectthePIRsensor.
• Toavoiddamagetotheunit,donotaimthesensor
towardsthesunorareasofstrongelectro-magnetic
disturbances.
• Toavoidnuisancetriggering,thesensorshouldbe
aimedawayfromheatsources,suchasBBQ’s,
Air-Conditioners,otheroutsidelighting,movingcars
andflueventsorreflectivesurfacessuchassmooth
whitewallsorswimmingpools.
• Whenselectinglocation,itisadvisabletonotethat
movementacrossthesensorsfieldismoreeffective
thantowards/awayfromit..
• Decideontheoptimumlocationfortheproduct.
Ensurethewalliscapableofholdingtheweightof
theproduct.
• Placetheproductinanuprightposition.
• Removethescrewfromthebaseoftheproductand
setasideforrefittinglater.
• Todetachthewallbackfromtheproduct,press
downthebutton(ontopofthebatterybox)withone
handandpulltheribbontabwiththeotherhand.
• Usingthewallbackasatemplate,markanddrillthe
positionofthefixingholes.
• Fixthewallbacktothewallusingthescrews
andwallplugs.Takecaretoavoiddamagingany
concealedwiringandpipes.Thecorrectfixings
shouldbeusedforbrickorcavitywalls.
• Fitthebatteries,ensuringthe"BatteryCare"
warningsonthepreviouspageareheeded.
• Pushthebuttonontopofthewallbackdownwith
onehandandpushtheproductontothewallback.It
willclickinplace.Refitthescrewtothebaseofthe
producttosecureinplace.
• Switchontheproductusingthetoggleswitchand
adjustthePIRsensorasdetailedbelow.Pleasenote
thesensorrotatesforeasyaccesstothecontrols.
Linethewhitedotsupatthefrontoftheproductto
ensurethecorrectorientation.
• Yourlightisnowreadyforuse.
Installation
PIR Adjustment
• Theunitmustbe installed inavertical position,and
fittedbetween1.8and2.5mabovetheground.
• ThePIRsensorcanbeadjusted,allowingthedetection
distance to be altered to suit the location. The
detection angle is set at 130 degrees. The duration
thatthelampstaysoncanbealteredfrom5seconds
- 1 minute. The detection distance "SENS" can be
adjustedfrom1.5mto8mUseasmallscrewdriverto
adjustthe‘TIME’and‘SENS’screws.Whenadjusting
thesensitivity(detectiondistance)indaylightitwillbe
necessarytocoverthesensortosimulatenighttime.