SBG ELLIPSE Series User manual

Ellipse Series
Miniature Inertial Systems
Quick Start Guide
Document ELLIPSEQSG
Revision Jun 30 2020
Support EMEA [phone]
[email protected]
Americas: [phone]
[email protected]

Ellipse Series – Quick Start Guide ELLIPSEQSG
Following instructions will help you to start quickly with your new Ellipse Device. Please read
and follow it carefully before plugging the device or installing software.
Content of a development Kit
1. A transport case
2. This quick start guide
3. A USB cable
Depending on options some additional items may be included such as GPS antenna or cables.
Software Development Kit Installation
1. Download the latest SDK from SBG Systems support website:
https://www.sbg-systems.com/setup
2. Launch the Inertial SDK executable.
3. Follow the instructions.
4. Once Inertial SDK is installed you can plug the USB cable on your computer with Ellipse
connected to it.
5. When you first launch sbgCenter application and try to connect to your Ellipse (see
section “Connecting to Ellipse” below) a message will ask you to change FDTI USB serial
converter configuration (see Figure below). Please follow instructions to ensure proper
operation.
2/4

Ellipse Series – Quick Start Guide ELLIPSEQSG
Getting Started with the Ellipse
Connecting to the Ellipse
1. Click on the icon. A
window will appear to list
every attached device.
2. Click on Refresh button to
update the device list
select your sensor.
3. Finally press “Connect” to
start working.
Displays
The sbgCenter provides a wide range of displays to visualize your sensor data such as 3D Cube
or Cockpit view for orientation display 2D Map Time series graphs GNSS data Device status
UTC Time & data and more.
3/4

Ellipse Series – Quick Start Guide ELLIPSEQSG
Configuration
In order to configure the Ellipse you
should click on the Toolbox
icon on sbgCenter task-bar to
access the different configuration
sections of the Ellipse:
Communication: sbgECom library
A convenient way to interface an Ellipse with C programs is to use the sbgECom library. With
simple C functions you can retrieve the device's output very quickly. Library source code is
provided with example to help you to start. Look here:
C:\Program Files\SBG Systems\Inertial SDK\Ellipse\Software Development
Interface with existing systems using NMEA and third party protocols
The Ellipse provides a wide range of input / output options. NMEA protocol as well as other
third party protocols support will ensure seamless integration into your application.
Find out more
You will find the full Ellipse documentation within the Software Development Kit:
The Ellipse Hardware Manual provides deep information about your Ellipse features and
explains in details how to install and use it.
The Ellipse Firmware Reference Manual provides low level protocol specifications as well as
advanced features information.
Several “Operating Handbooks” are also available to guide you in a step-by-step way into
typical applications configuration.
The Technical Reference Manual provides in details the common concepts used in the whole
SBG Systems line of Inertial Systems.
4/4