Scale Graphics Spektrum 2.4 Ghz Series User manual

Radio System for use with 2.4GHZ RailBoss R/C
Channel Assignments
Rx
Left Stick Up/Down Direction Fwd/Rev Elevator ELEV
Left Stick Left/Right Sound Bell/Whistle Rudder RUDD
Right Stick Up/Down Speed 0 to 00% Throttle THRO
Right Stick Left/Right Momentum Off/On Aileron AILE
ode 2 (Throttle on Left)
Left Stick Up/Down Speed 0 to 00% Throttle THRO
Left Stick Left/Right Momentum Off/On Rudder RUDD
Right Stick Up/Down Direction Fwd/Rev Elevator ELEV
Right Stick Left/Right Sound Bell/Whistle Aileron AILE
ode 1 (Throttle on Right)
Parts Numbers
Transmitters
DX5e 5-Ch
DX4e 4-Channel
MLP4DSM 4-Channel
Spektrum Receivers
AR500 5-Channel
DS 2 Compatible Receivers
Orange Rx 6-Channel
DX6i 6-Channel
AR-6100 6-Ch
Notes:
) RailBoss will work with 4 channels, but for two train operation you
need 5 channels.
2) Receivers featuring the “SmartSafe” failsafe are not compatible with
the RailBoss (AR600, AR63 0, AR6 00, and others. During loss of TX
signal, the receiver elevator channel must stop sending pulses (no
output, zero volts).
Trim Adjustments should be in the center position at all times.
(See Spektrum Tx manual)
Set all Servo Reverser switches to the Normal (down) position.
Set the Hi Lo Rate switch to HI.
Recommended Radio System:
Purchase a Spektrum DX5e Transmitter (only) from your local hobby
shop or on-line (about $69).
Purchase DS 2 compatible receivers from G-Scale Graphics to in-
sure compatibility and get the lowest cost (about $15).

www.GScaleGraphics.net
4 8 Clayton Ct., Fort Collins, CO 80525-3444
970-58 -3567
[e-mail]
Radio System for use with 2.4GHZ RailBoss R/C
This information is provided as a service to our customers. We do not sell this product.
Connect the Receiver as shown in the RailBoss manual.
The 3-wire throttle connection supplies power to the receiver.
There should be no connections to the “B” (battery) pins.
Install the “Binding Plug” in the receiver at the BATT position.
This shorts the data pin (left) to the ground pin (right).
Turn power ON to the RailBoss. The receiver LED will start flashing.
Set the throttle stick to the full DOWN position. (This insures RailBoss will work properly when Tx is Off)
Hold the TRAINER switch in the ON position while turning on the transmitter.
The LEDs on the transmitter will start flashing. Release the TRAINER switch.
Wait for the receiver LED to stay ON solid.
Remove the “Binding Plug” from the receiver.
Important: Remove the plug before turning off power!
Turn off the transmitter and the RailBoss.
Now you need to calibrate the transmitter’s throttle to the RailBoss following the RailBoss manual instruc-
tions for “Throttle Calibration”.
Binding Procedure
“Binding” is the process of sending a code from the transmitter to the re-
ceiver. After binding, the receiver will only process commands that come
from the binding transmitter. All others will be ignored. Thus there is no
need for separate frequencies. More than one receiver can be bound to the
same transmitter.