Schaller Signum Bridge User manual

User Guide
&
Product Information
Content of Schaller Signum Bridge
–1 Signum bridge
–2 Signum locking studs
–2 Signum locking stud bushings
–1 Signum locking key
–2 pairs of Allen screws (6 mm / 10 mm)
with the 6 mm pair pre-installed
–1 Allen key
– 2 – – 3 –
Before you get started please follow
these important instructions:
Never attempt to turn height adjustment
screws/studs while bridge is locked!
Always loosen locking hex nuts before
adjusting bridge height! 
Lock and open hex nuts according to laser
inscription on Signum locking key.
Adjust overall height of bridge - i.e. string
action - just like on any regular wraparound
bridge or stop tailpiece.
tighten
loosen

– 4 – – 5 –
Install and Adjust Your Signum Bridge
1. Use Signum locking key for fastening
locking hex nuts only just lightly to prevent
bridge from tilting.
2. Adjust bridge height by turning studs
as usual - counterclockwise for up and
clockwise for down.
3. Use Allen screws if needed . Chose from
two diff erent lengths (6 mm / 10 mm) to
prevent screws from sticking out.
4. Adjust individual string intonation back and
forth by way of the string saddle screws.
5. Lock bridge but do not overtighten locking
hex nuts.
6. When stringing up make sure ballends
are sunk all the way into the rectangular
recess to prevent strings from accidentally
unwinding.
superb tone and sustain
•
elegant shape and low profi le
•
special design Signum locking studs
•
state-of-the-art string saddle shaping
•
unparalleled playing comfort
•
vast 9.5 mm saddle travel
•
optimized string-through-bridge routing
•
rectangular ball end retainer
© 2016 Schaller Electronic GmbH
www.schaller-electronic.com
locking hex nut closed
counter thread
for locking
hex nut
locking hex nut open
thread
for height
adjustment