WInstruction sheet: Sat Multiswitch 9 in 8, HSATS908ER
PAGE 1/2
INSTRUCTION SHEET: HSATS908ER_E / 02-2015
Errors and omissions excepted.
SCHRACK TECHNIK GMBH
Seybelgasse 13, A - 1230 Vienna, PHONE +43 1/866 85-0
wSchrack-Info
• No loss at SAT-range
• High modulation / high signal-quality
• Low power consumption
• Short-circuit proof
• Made in Germany
wUsage
Multiswitch HSATS908ER distributes the signals of your satellite system to up to 8 devices (satellite receiver, TV sets with
satellite tuner, etc.).
Using a Quattro LNB, make sure that vertical/horizontal and low/high band signals are connected correct.
The terrestrial input is designed for using with a DVB-T / FM antenna.
wSafety Instructions
Please check first the coaxial cable regarding short circuit before starting!
The mounting ground should be:
• even and flame proof
• dust-free
• protected against humidity
• not under direct impact of sunlight
• not adjacent to heating sources
The ventilation slots of the power supply unit may not be covered.
It is to be paid attention to it that the input levels of the SAT-lines are equivalent high.
All installation and fixing of components should only be executed when the units are disconnected from the mains supply.
Avoid short-cricuits.
The applicate standards and regulations for the guarantee of electrical security are to be considered.
The national regulations for broadcast recording systems have to be observed!
