Schulz Speyer Concertina User manual

Assembly Guide
Concertina

2
Assembly guide
Assembly guide for Concertina
Pos. Specifications
A. Tape (Scotch Bronel), length 35 cm
B. Bosscod 4 mm BN 717
C. Sheet metal screw 4,8X13 mm
D. Cylinder nut M6X13 mm JS no. 4081 961013
E. 6X45 mm HFC 683
F. 4X20 mm HFC 681
G. 4X30 mm chip board screw HFC 328
H. Combi screw 4X10 mm 520-818910
I. 4,5X 16 mm chip board screw HFC 328
J. 4 mm wing nut HFC 9915
K. 5 mm tension disk HFC 9167
L. 1 meter mini bracket LC 57
M. Clip pulley HFC 9167
N. Häfele house 262.26.811
O. Häfele joint bolt 262.28.811
P. Spring 3,6X18 mm

3
Assembly guide
Assembly guide for Concertina

4
Assembly guide
Assembly guide for Concertina

5
Assembly guide
Assembly guide for Concertina

6
Assembly guide
Assembly guide for Concertina
Straight
Curved

7
Assembly guide
Assembly guide for Concertina

8
Assembly guide
Assembly guide for Concertina

9
Assembly guide
Assembly guide for Concertina

10
Assembly guide
Assembly guide for Concertina

11
Assembly guide
Assembly guide for Concertina
Manual adjustable

12
Assembly guide
Assembly guide for Concertina
Electrical adjustable

13
Assembly guide
Assembly guide for Concertina

14
Assembly guide
Assembly guide for Concertina

15
Assembly guide
Assembly guide for Concertina

16
Assembly guide
Assembly guide for Concertina

17
Assembly guide
Assembly guide for Concertina

18
Assembly guide
Assembly guide for Concertina
Electrically adjustable module: Adjustment instructions
If electrically adjustable Concertina desk surfaces have an uneven weight load or intensive use
condition, the motor will on occasion require calibration.
The facility staff can easily accomplish this by lowering the unit(s) to what is termed a zero position or
the lowest possible point of adjustment and press the button for a minimum of 5 sec.
Alignment may be required two to four times a month or even daily depending upon the adjustment
usage.

19
Assembly guide
Assembly guide for Concertina
Safety instructions for the Desk Power System
Safe use of the system is possible only when the operating instruction are read completely, and the
instructions contained are strictly observed.
Failure to comply with instructions marked with “NOTE” may result in serious damage to the system
or one of its components.
NOTE: It is important for everyone who is to connect, install or use the systems to have the necessary
information and access to this user manual.
NOTE: If there is visible damage on the product it must not be installed
Before installation, de-installation or troubleshooting:
Stop the Desk Power System
Switch off the power supply and pull out the main plugs.
Relieve the Desk Power System of any loads, which may be released during the work.
Before start-up:
Make sure that the system has been installed as instructed in this user manual.
Make sure that the voltage at the control box is corrected before the system is connected to the
mains.
System connection. The individual parts must be connected before the control box is connected to the
mains.
During operation:
If the control box makes unusual noises or smells switch off the main voltage immediately.
Take care that the cables are not damaged.
Unplug the main cable on mobile equipment before it is moved.

20
Assembly guide
Assembly guide for Concertina
Control for adjusting the table height