23
INSTALLATION GUIDE INSTALLATION GUIDE
Disassembly
Disassembly
Kit Assembly
Step 1 Step 4
Step 2
Step 3
Use a panel removal tool (PRT) to
carefully pop out the side trim panels
of the center console & remove. (Right
Photo)
Open cup holders and use a
small at screwdriver or pick
tool to unsnap/remove the
rectangular front trim pieces
from each. (Right Photo) Push
cup holders back in.
Lift center console wood trim out,
unplug & remove. (Right IMG)
Extract (2) Torx screws, one from from each outer side of cup holders and
remove. (Not shown in photos)
Carefully slide out OEM radio. Radio
is held in with alignment/support hooks
on the top/bottom within the dash
cavity. Disconnect and remove. Right
IMG
Step 5
Step 6
Step 7
AB
B
C
C
A
Use a T20 Torx driver and remove (3) Torx screws from each side of the
console (Bottom Photo). Smaller head Torx screws holding the wood trim.
(Photo enlarged for detail: A, B, C). Some vehicles may have 2 additional
Torx screws hidden in the armrest console storage securing the back edge of
wood trim. (Not shown in this step)
Use a PRT to carefully unsnap shifter trim. (Not shown in photos)
The metal side brackets will
be attached to the sides of the
Aftermarket Double DIN stereo.
The copper color metal clips t
BETWEEN the radio chassis and side
brackets with the spring tabs facing
AWAY from the stereo. These clips set
the position of the radio within the kit
opening. Test t and adjust the side
clips so the nose of the Aftermarket
stereo is ush with dash kit panel
when snapped into place.
(Sample Photo)
MZ2351B 01/16MZ2351B 01/16
