Sealey MK50.V3 User manual

INSTRUCTIONS FOR
PANEL STAND
MODEL NO: MK50.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9Familiarise yourself with the application, limitations and hazards of the panel stand.
9Maintain the panel stand in good condition (use authorised replacement parts).
9Keep the panel stand clean for best and safest performance.
9Locate the panel stand in a suitable work area.
WARNING! Use the panel stand on level and solid ground, preferably concrete.
8DO NOT overload the panel stand.
8DO NOT climb on the panel stand.
8DO NOT use the panel stand for any purpose other than for which it is designed.
8DO NOT use the panel stand if any parts are damaged or missing as this may cause failure and/or personal injury.
9Keep the work area clean, uncluttered and ensure that there is adequate lighting.
9Keep children and unauthorised persons away from the work area.
WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations that
may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be
applied by the operator.
2. INTRODUCTION
Versatile stand suitable for a wide variety of body shop applications. Work height is fully adjustable by lengthening chains. Foam cushioned
supports help prevent marking panel. Folds away when not in use.
3. SPECIFICATION
Model No................................................................. MK50.V3
Width........................................................................ 1000mm
Folded Height........................................................... 1100mm
4. ASSEMBLY
4.1. Push rubber feet on to ends of legs as shown.
4.2. Slide legs fig.1.1 into panel supports fig.1.2 and fix using hook
bolts fig.1.3 as shown.
4.3. Bolt the two halves of the stand together using the bolts / nuts /
washers supplied. Ensure hooks face inwards.
4.4. Suspend the chains between the hooks as shown to obtain
required height.
4.5. Panel stand can be folded up when not in use for ease of storage.
WARNING! Take care not to trap fingers.
MK50.V3 | Issue 1 23/08/16
Original Language Version
© Jack Sealey Limited
Refer to
instructions
g.1

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
[e-mail]
01284 757500
01284 703534
MK50.V3 | Issue 1 23/08/16
Original Language Version
© Jack Sealey Limited
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.