Sealey MS081FS User manual

FREESTANDING MOTORCYCLE HELMET &
GEAR TIDY
MODEL NO: MS081FS
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
8DO NOT locate this tidy in such a position as to create the risk of injury from contact with the head or any other part of the body.
8DO NOT overload this tidy; it should only be used for the designed purpose.
8DO NOT locate in a position where items could fall from the tidy owing to accidental contact.
9Ensure that, when installed, it can be used without over-reaching or over-balancing.
2. INTRODUCTION
Powder coated steel construction, for added corrosion resistance. Freestanding unit, designed to organize the storage of gloves, clothing, boots
and helmet. Adjustable shelves allows for easy storage of up to four helmets. Strong construction, shelf capacity of 18kg and hanging rack
capacity of 10kg. Large capacity, capable of storing two full sets of kit and more.
3. SPECIFICATION
Model No: MS081FS
Depth: 460mm
Height: 1925mm
Width: 545mm
4. ASSEMBLY
4.1. Refer to diagram alongside.
5. CARE
5.1. Clean with a soft, damp cloth.
8DO NOT use abrasive or solvent cleaners.
MS081FS Issue 1 12/10/22
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Step 1
Fit lower
section of uprights
into base unit
Step 2
Fit triangular braces
with fixings supplied.
Step 5
Adjust feet to ensure
good contact with
floor
Step 3
Insert upper
upright
sections
into
lower uprights
Step 4
Fit shelves into
uprights at desired
height

MS081FS Issue 1 12/10/22
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste.All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations. REGISTER YOUR
PURCHASE HERE