SEARIAL CLEANERS BEBOT Setup guide

QUICK START USER GUIDE
BEBOT

2Quick Start
BeBot
BEFORE FIRST USE
Charging
Open the side panels of the box to access the Bebot. Do not unload.
Charge the Bebot overnight, batteries must be charged 100% before rst use.
Starting the BeBot
1. Make sure the batteries are plugged to the system
2. Turn the red button on, at the top of the X-Bot. An
Orange light will ash.
3. Always turn o the remote when stepping in the
“working area” (2m around BeBot)
4. Turn on the remote by pushing the silver center button
upwards. The remote will beep
5. Push the right stick downwards (one short push): the
remote will connect to the X-Bot
Attaching the sand sifter
1. Align both X-Bot palette and Sand Sifter palette.
2. Move the Xbot backward to align the sand sifter docking
systems and the Xbot.
Warning: Never plug or unplung the Sand Sifter when Xbot
is on
3. Turn o the X-Bot, plug the Sand sifter cable at the back
of the Xbot.
4. Turn the X-Bot on again.
Don’t go forward with the X-bot to the risk of tearing the
cable out.
5. Lock the docking systems together, using the right stick
of the remote to go upwards and downwards.
6. Once the sifter is locked, place the pin in.
Ramps are supplied to allow a safe descent of the Bebot
from the pallets
Raise the sifter to the maximum height and drive of the
palette using the ramp.
Unloading the Bebot

3
Quick Start
BeBot
Storage
Strictly store the Bebot in a dry environment, with a temperature between 5 to 30°C // 41 to 86°F.
During storage, battery must be recharged every 3-5 weeks to prevent battery damage. Do not leave the batteries
discharged for more than 48h.
After each use clean the Bebot:
• We recommend using an air blower to remove the sand easily.
• Water can be used. Do not spray water on the electronics box and batteries
Safety rules
• Make sure you are clear from the working area, 2 meters around the Bebot
• If you need to get in the working area, wear safety shoes and gloves.
• Do not lay under the sand sifter when it is in up position.
• Do not open the rear door of the sand sifter when it is in downward position.
Batteries electronic box

www.searial-cleaners.com
AFTER SALES CONTACT
Email : [email protected]
Adress :
ROTAX MARINE
ZI LE MARAIS - Rue de l’Insdustrie
01460 PORT