6
Copyright © 2016 – Secura Inc. - All rights are reserved. http://www.thesecura.com
setting is used. Caution: Never change the grind setting while the grinder is running!
7.Use the Cup selector dial (G) to pick the number of cups of coffee you will be brewing
(from 2 to 10). The amount of ground coffee yielded varies quite a bit, depending on how
coarse or fi ne you grind and whether you use light, dry beans or dark, oily beans. After
grinding a few times, you will fi nd the correct cup selector setting for the amount of coffee
you want to grind.
8.Push the On/Off Button (H) to start your grinder. The grinder will begin grinding the
coffee directly into the Ground Coffee container (D). It will stop automatically after reaching
the amount of ground coffee associated with the cup setting chosen. Note: If you need to
turn the grinder off before the grinding cycle is fi nished, press the On/ Off Button once.
9.During grinding, if either the Coffee Bean container (B) or Ground Coffee container (D)
is removed, the grinder will stop operating.
10.To avoid the unit jamming with grounds, NEVER turn the unit on if the Ground Coffee
container (D) has fi lled to the “MAX” level.
11.To avoid overheating the motor, do not grind more than 2 full, 10 cup cycles, without a
break. Allow the motor to cool at least 5 Minutes between cycles.
CLEANING/ REMOVING THE UPPER GRINDER BURR
Remove the coffee bean container & lid from the top housing by rotating it•
counterclockwise until the arrow on the side of the container reaches the OPEN
position, and then lift it straight up.
Remove the ground coffee container & lid by pulling it directly out of the base.•
Turn the upper grinder cone counterclockwise until it is loose and lift it out.•
Clean both the upper and lower grinder cones with a small brush.•
Replace the upper grinder cone into the grinder and turn it clockwise until it fi xes into position. •
SECURA AUTOMATIC CONICAL BURR COFFEE GRINDER