Secure SCS100-000 User manual

www.securemeters.com
BGX701-292-R02
BGX7 0 1 - 2 9 2
SCS100-000
Temperature Sensor THS
To be used with Secure Controls products
In the box
Ideal mounting location
Locations to avoid
Secure Controls
temperature and
humidity Sensor
21.0
1.5 m
21.0
Technical specifications
Operating temperature range
Pollution degree
Ingress protection
Operating humidity
Storage temperature range
Battery specifications
Battery life
Wireless communication frequency
Compliance
0°C to 40°C
2
IP30
2 x AAA type batteries (1.5 V each)
0% to 95%, relative humidity, non condensing
-20°C to +70°C
2.4 GHz RF
Up to 3 years
EN300 489 -1 (Radio EMC), EN 300 489 -17
(Radio EMC broadband data transmission),
EN300 328 (2.4GHz wideband), RoHS
Secure Meters (UK) Ltd
South Bristol Business Park,
Roman Farm Road, Bristol, BS4 1UP
United Kingdom
Bristol Phone: [phone]
UK Free Phone : [phone]
UK Direct : [phone]
[email protected]
Copyright © 2020-21, SIHPL
RF
damage to the equipment.
As part of Secure Meter's continuous endeavour to improve, product design
and specifications mentioned are liable to change. System functionality
information, illustrations and product aesthetics published in the document
may vary from those of your product.
ŸInstallation should be done by trained personnel only.
ŸLocal best practices and regulatory stipulations must be observed.
ŸDo not use solvents or abrasive materials to clean the device, use only a
anti-static cloth.
Follow these instructions and safety measures to avoid risk of injury or

Drilling and nailing
X
12
3
Battery replacement Battery replacement
1
2
3
C1 C2
4
5
6
Insert new batteries ensuring
correct polarity.
Dispose old batteries
according to local
regulations
M3.5, AB
type screws
Remove
battery
strip
Commissioning and mounting the THS
On the Secure Controls PTD, Press the Menu button at the top to enter the main
menu.
1
Navigate to Settings menu using +/- buttons and press Home-Away to enter.
2
3Navigate to Add Sensor option using +/- buttons and press Home-Away to enter.
6PTD will search for the sensor and display the sensor serial number. To verify the
number, check the sticker on the sensor. Press Home-Away to confirm
The Remove battery strip screen appears. Make sure to remove the battery strip on
the THS and press Home-Away to confirm.
5
4Select Zone screen appears. Select the respective zone by using +/- buttons and
press Home-Away to enter.
7When the sensor is paired, a confirmation message will appear.
Note: You will need Secure Controls PTD installed
and commissioned to perform these steps.
8Mount the THS.
12
-+
Menu button
Note: If the battery strip is already removed, do the following:
1. Open the battery cover and remove both the batteries.
2. Wait for 8-10 seconds and re-insert the batteries.
3. Replace the cover back.