Security Brands REMOTE 300 User manual

ON
12345678910
INSTRUCTIONS REMOTE 300 Model 14-R300
1 of 2
IN THE BOX
Make sure you have everything shown here.
NOTE: The CR2032 battery comes pre-installed.
Remote 300 Visor Clip
Button 1
LED
Button 2
DIP Switches on Receiver 300
(default positions)
WHAT’S WHAT
The Remote 300 has two programmable buttons and
a status LED. Each button can be paired to a separate
receiver or the same receiver.
SETUP
1. On your 300-MHz receiver, set DIP switches to
desired positions.
NOTE: For best results, we recommend using
the Security Brands Receiver 300 (14-REC300).
NOTE: By default, both sets of DIP switches on
the Remote 300 are matched to the default DIP
switch positions of the Receiver 300 and other
300-MHz receivers. For security reasons, we
recommend using custom DIP switch positions.
NOTE: Some DIP switches may be labeled
dierently. The position labeled 10 corresponds
to the position labeled 0 on the remote, and
the DIP switches on some receivers have the o
position labeled as OPEN.
2. Open Remote 300 unit by removing two screws
on bottom side and pulling case apart. Remove
visor clip if needed for easier access.
NOTE: Make sure the circuit board stays
attached to the base of the remote unit and
does not come o with the cover.

call
[phone]
or email
[email protected]
NEED
HELP
Two-Year Limited Warranty
Visit securitybrandsinc.com/warranty/ for details
1234567890ON
INSTRUCTIONS
2 of 2
REMOTE 300 Model 14-R300
© 2021 Security Brands, Inc. All rights reserved. I-14R300-EN Rev. A (5/2021)
WARNING! AUTOMATIC GATES CAN CAUSE
SERIOUS INJURY OR DEATH!
ALWAYS CHECK THAT THE GATE PATH IS
CLEAR BEFORE OPERATING!
REVERSING OR OTHER SAFETY DEVICES
SHOULD ALWAYS BE USED!

3. Find DIP switches on Remote 300 unit
corresponding to button you want to program.
NOTE: Pay attention to the markings on the
circuit board showing which set of DIP switches
corresponds to which button.
4. Set DIP switches to match those set on receiver.
5. Repeat procedure for second button if desired.
Otherwise, close unit and secure with screws.
NOTE: The second button can be paired with the
same or a dierent 300-MHz receiver.
HOW TO USE
1. Make sure you are in range of 300-MHz receiver
you want to control.
2. Press remote button linked to desired receiver.
LED should light.
3. Receiver will respond and operate gate/door.
NOTE: If the receiver does not respond, make sure it
has power and that the remote LED is lighting when
a button is pressed. If not, check the battery. If the
receiver still does not respond, make sure its antenna
is not inside a metal box, the DIP switch positions
match on both remote and receiver, and if it is a
third-party receiver, make sure the frequency jumper
is in the 300-MHz position.
DIP Switches on Remote 300
(default positions for both buttons)