Segway 1689500001 Reference guide

Customer Installable Parts
Upper Cargo Structure & Bag
e Series and i Series Models Only
Kit Number: 1689500001 Contents
·1 handlebar bag
·1 bag lid
·1 wire mounting frame
·1 control shaft clamp
·1 clamp screw
·2 button head screws
Specifications
·10 lb. maximum carrying capacity
·Polypropylene and polyethylene construction
·Polyester and mesh soft-sided pockets with cord locks
·Stainless steel snaps on bag lid
·Hook and loop attachment straps
·Powder-coated stainless steel wire mounting frame
Tools Required
·2.5mm hex wrench
·4mm hex wrench
WARNING
Always shut down your Segway HT and unplug the charge cord before performing any maintenance or installing any part or
accessory.
Follow these instructions carefully. Failure to follow these instructions carefully could damage your Segway HT and render it
unsafe to use.
Before you begin:
Do not use the parking stand to support the Segway HT while performing this procedure. The parking stand
is not designed to withstand the forces that may be generated. Instead, lay the Segway HT down on its back
side or support it with other objects so that you have easy access to the front of the handlebar and control
shaft.

Installation
Step 1
If present, remove the two button head
screws located on the bottom of the
handlebar using a 4mm hex wrench.
Step 2
Align the holes in the wire frame with the
screw locations in the bottom of the
handlebar so that the frame is on the front
side of the control shaft.
Step 3
Install the two button head screws through
the holes in the wire frame and into the
bottom of the handlebar using a 4mm hex
wrench and torque to 7.5 N-m.
Step 4
Install the clamp on the control shaft just
above the height adjustment collar with the
hook facing forward and up.
Note
Replace any fasteners you remove when performing this
installation with the new fasteners included in this kit .
Step 5
Slide the clamp up to the wire frame so that the wire frame rests in the hook.
Step 6
Install the clamp screw and with a 2.5mm hex wrench torque to 1.5 N-m. (The gap between the halves of the
clamp should be about 4mm.)
Step 7
Lightly tap the wire frame so that it snaps in the hook of the clamp.
Step 8
Drape the cargo bag over the handlebar so that the Display and Key Port are not obstructed.
Step 9
Secure the hook and loop straps around the wire frame at the bottom and sides of the bag.
>
LIMITED WARRANTY The Segway HT Upper Cargo Structure and Bag is an accessory covered by the SegwayTM
Human Transporter Limited Warranty (copy delivered with this kit).
Questions?
If you are missing a part, or if you need to return the product please contact Segway Customer
Service at 866.4SEGWAY (866.473.4929) or on our website at
www.segway.com/support/contact_us.html.