SEI FA583500TX User manual

FA583500TX
Copper Finish Gel Corner
Fireplace
Assembly Instruction
For assistance with assembly contact:
Southern Enterprises Inc.
Customer Service 1-800-633-5096
[email protected]
www.seidal.com
©Southern Enterprises Inc. All Right Reserved.

Tool List: 1/4" drill bit, drill, tape measure and pencil .
FA583500TX
Copper Finish Gel Corner Fireplace
Parts List
Please review all parts and hardware before disposing of any packaging.
Call Customer Service if missing hardware. Do not return to sto re/retailer.
Screws shown actual size. Using a screw that is too long will cause damage.
Before beginning assembly, separate each type of screw. Carefully study
the screw diagrams below.
Suggested tools: Phillip s head screw driver, power drill, ¼” dri ll bit, 24”
level, and a tape measure. Unit needs to be hung on wall stud for more
security and stability.
(1) Candle Holder 1 PC
(2) Fuel Canister holder
3 PCS
(3) Top Frame 1 PC
(4) Bottom Frame 1 PC
(5) Grill Front Panel
1PC
(6) Insulation Foam
1PC
(9)Screw 19PCS
3/16x10mm
(10)Nut 5PCS
(7) Right Panel 1 PC
(8) Left Panel 1 PC
(11)Open rench 1PC
Care and Cleaning Instructions:
Before using, wipe with a clean, dry cloth.
Avoid rubbing or scratching the
surface with rough or abrasive objects.
For replacement parts or questions, please
call Customer Service at 1 -800-633-5096.
Do not return product to store. Please call
manufacturer for assistance, questions or parts.
Assembly Tool Required
No.2 Phillips Screwdriver

FA583500TX
Copper Finish Gel Corn er Fireplace
Assembly Instructions
PLEASE USE IN WELLVENTILATED AREA
The fireplace will have open flames and will generate heat.
Make sure to keep all combustible items away from the fireplace when the gel fuel is
burning.
DO NOT touch the fireplace wh en the gel fuel is burning.
Not recommended for use on wall paper or wood paneled walls due to risk of
discoloration over time ..
1. Attach right panel (7) to left
panel (8) by using screw (9) and
nut (10) as shown.
Figure 1

2. Attach top frame (3) and
bottom frame (4) to side panels
by using screw (9) as shown.
3. Put insulation foam (6) at the
corner of floor then put on
fireplace as shown. .
Figure 3
Figure 2

4. Remove the three fuel canister
holders (2) from the fireplace and
install one gel fuel canister(1,
Figure 4 ) into each of the
holders.
NOTICE
Make sure to remove the gel fuel
canister paper label (4,Figure 4 )
before installing the canister into
the holder.
Shake the gel fuel canister before
installing it into the canister
holder.
5. Install the gel fuel holders into
the fireplace into the appropriate
mounting hole (3, Figure 4) in the
fireplace.
6. Following the instructions on
the gel fuel canister, remove the
lid (2,Figure 5 ) from the gel fuel
canister (1,Figure 5 ), and using a
long match, light the fuel in each
of the canister. Candle holder can
be used to extinguish fire.
Figure 5
Figure 4

7. Inserting grill front panel (5) as
shown.
Figure 6

PROLONGED USE OF THE GEL F UEL IN THE FIREPLACE WILL CAUSE THE FIREPLACE
TO BECOME HOTAND POTENTIALLY CAN CAUSE BURNS IF TOUCHED.
DO NOT BURN MORE THAN THREE CANISTERS OF FUELAT ONE TIME.
BEFORE LIGHTING THE FUEL, MAKE SURE THAT THE PAPER LABEL IS REMOVED
FROM EACH OF THE GEL FUEL CANISTERS.
USE LONG MATCHES TO LIGHT EACH CANISTER OF FUEL.
DO NOT TOUCH THE CANISTERS WITH BARE HANDS UNTILTHE FLAME HAS BEEN
EXTINGUISHED FOR 20 MINUTES.
DO NOT BURN ANYTHING EXCEPT THE SPECIFIED CANISTERS OF GEL FUEL IN THE
FIREBOX.
KEEP CHILDREN AWAY FROM THE FIREPLACE WHEN IN USE.
KEEP FLAMABLE OBJECTS, SUCH AS CURTAINS OR DRAPERYS, AWAY FROM THE
FIREPLACE WHEN THE GEL FUEL HAS BEEN IGNITED.
MAKE SURE THE CUSTOMER DOES NOT PLACEANY DECORATIVE ITEMS ON TOPOF
THE UNIT ATANYTIME.
DO NOT TOUCH THE UPP ER PART OF THE UNIT WHILE IT IS STILL IN OPERATION.
THE CANDLE HOLDER ACTSAS ACOVER TO PUT OUT FIRE IF ONE WISHES TO STOP
THE FLAME.
NEVER LEAVE BURNING GEL FUEL UNATTENDED.
CARE INSTRUCTION: WIPE DOWN UNITAND CANDLE HOLDER WITH SOFT DAMP
CLOTH.
WHEN USING THE CANDLE HOLDER PLEASE MAKE SURE THAT THE CANNISTER
HOLDERS ARE IN PLACE.

We'd love to hear from you! Email us photos of our products in your home at
[email protected] and we might feature it on our site or use it to model one of our inspirational
photos.
“PARTS WILL BE SENT IF AVAILABLE FROM SEI”
Parts Replacement Form
Customer Information
Name
Address
City/State/Zip Code
Phone Number
Please indicate where you purchased this item: Store/ Website/ Catalog
Please indicate color/size/style number:
Style No
Parts Letter
Parts Description
Quantity Needed
Missing or damaged hardware and/ or parts will be replaced free of charge. We do not sell parts. Southern
Enterprises Inc. will provide replacement parts for only those items purchased within the last 9 months. If this
product has not been purchased from our retail affiliates (within 9 months), we are under no obligation to
provide parts or replacements merchandise. Parts will not be available for items arriving fully assembled.
Customer Service 1-800-633-5096
[email protected]
Southern Enterprises, Inc.
600 Freeport Parkway, Suite 200
Coppell, Texas 75019