Seicane S085991 Guide

www.seicane.com
Seicane S085991 2001-2011 Mercedes-Benz E Class G Class CLS Class aftermarket
car stereo head nit pgrade installation replacement instr ction
Seicane S085991 2001-2011 Mercedes-Benz E Class G Class CLS Class car stereo after installation
Please note:
This nit can be s itable for the following cars which are also with the same installation steps
as follows.
2002-2008 Mercedes-Benz E Class E200 E220 E2 0 E270 E280
2001-2008 Mercedes Benz G Class W 63 G550 G500 G 00 G320
200 -2011 Mercedes Benz CLS Class W219 CLS350 CLS500 CLS55
Before and d ring installation, yo sho ld notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult
the professional.
7. For your convenience, here’s the recommended tools for removal and installation from
Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-
srd- 00

www.seicane.com
2001-2011 Mercedes-Benz E Class G Class CLS Class car stereo installation g ide
1. The original car radio.
2. Use a lever to release the decoration panel and remove the cigarette lighter.
3. Remove two screws under the 6-disc CD changer and take out the CD changer.
. Remove the two screws marked with red arrows and pull out the CD player.

www.seicane.com
5. Check all the accessories for the new Seicane car radio.
5. Connect the cables in the package.
a. Connect with the power cable in the car.
b. Socket for the speaker cable plug in the car.
c. Connect CAN-H, CAN-L with CAN-BUS
d. Connect CAN-TX.

www.seicane.com
6. Remove the baffle-plate under the assistant driver seat, connect the CAN-H, CAN-L cable
(green)③ with the CAN-BUS socket marked in the picture.
7. Pry the decoration panel beside the driver's seat, change fuse from 5A TO 10A.
8. Remove the screws for fastening the car pc in the left of the trunk.
9. Find the amplifier in the left of the trunk and remove the four screws marked with red arrows.

www.seicane.com
10. Remove the amplifier in the car.
11. Connect the speaker cable with the speaker socket ②.
12. Turn on the new Seicane stereo to have a careful check if everything works well. If it doesn't,
please check whether all the cables are connected correctly.
13.Put the new Seicane radio into the dash.
1 . Put everything into their original place. All the installation is done.
Please note:
We suggest you arrange a professional to install it. If you have any questions about installation,
please send us photos about your original car's plugs, we can make a wiring diagram for your car.