Seima OROS 550 Assembly instructions

Looking after your Arqstone sink
Arqstone engineered stone is exceptionally strong, durable and easy to clean.
Arqstone sinks are designed for normal domestic use. Follow these guidelines to keep your Arqstone
sink looking beautiful.
− Avoid placing hot pans or objects directly onto the sink. Instead, use a wooden board, stainless
steel rollout mat or other device to protect the sink.
− Do not use the sink as a cutting surface. Use a cutting board instead.
− Avoid any strong chemical agents from coming into contact with the sink surface.
− Do not use abrasive cleaners or cleaning pads on the sink.
− Avoid leaving any strongly coloured substances (such as coee, tea, red wine, vegetable juice etc)
on the sink surface.
− Do not throw cutlery or other hard or pointed objects onto the sink surface, as this can damage
the sink.
How to clean your Arqstone sink
− For everyday cleaning, use warm water, liquid detergent and a soft cloth. Do not use abrasive
cleaners or chemicals.
− Spillages of strongly coloured substances (eg coee, red wine, vegetable juice etc) should be
wiped up straight away.
− For further care and cleaning guidelines, refer to seima.com.au/support
Arqstone sinks
Installation and care guide
Butler sink installation
12
Ensure that the surface to be siliconed, where the sink will be located,
is cleaned and free of grease. Ensure that the surface is level.
Apply a neat line of silicone as shown and position the sink in place.
Allow time for the silicone to cure before using the sink.
IMPORTANT! Use silicone sealant. DO NOT USE EPOXY TYPE ADHESIVES. Use of epoxy adhesives will void the warranty.
arqstone-in | v 1.0 | page 1 of 2
Please note:
Butler sinks can be
installed in a number
of ways. The most
common is under
the benchtop with
the sink extending
beyond the front of
the cupboards.
Sinks can also be
installed level with
the benchtop,
or even above
benchtop level.

Undermount sink installation
Abovemount sink installation
Use the cutting template to draw and cut a
precise hole in the benchtop. Make allowance for
any polishing back that is required after cutting.
Finish the hole rim.
Place a neat line of silicone
sealant around the sink rim.
Carefully locate the sink
under the benchtop. The
silicone will attach the sink
to the benchtop.
Support and place upwards pressure
on the sink to keep it in place while
the silicone is curing.
Use silicone to seal the gap between the
benchtop and sink. Take care to ensure that the
silicone is not visible.
1 2 3 4
5
1 2 3
4
Use the cutting template to draw and cut a
precise hole in the benchtop.
If your sink has clips, use clips as well as
silicone. Place a neat line of silicone under the
rim of the sink and position the sink in place.
Arqstone sinks
Installation and care guide
IMPORTANT!
Use silicone sealant.
DO NOT USE EPOXY TYPE ADHESIVES.
Use of epoxy adhesives will void the warranty.
IMPORTANT!
Use silicone sealant.
DO NOT USE EPOXY TYPE ADHESIVES.
Use of epoxy adhesives will void the warranty.
arqstone-in | v 1.0 | page 2 of 2